Demonstration of a power-recycled Michelson interferometer with Fabry-Perot arms by frontal modulation.
نویسندگان
چکیده
Large-scale gravitational-wave detectors currently under construction such as the LIGO detectors use multiplemirror resonant optical systems containing several surfaces at which the relative phase of interfering light beams must be controlled. We describe a tabletop experiment that demonstrates a scheme for extracting signals in such an interferometer corresponding to deviations from perfect interference.
منابع مشابه
Strawman LIGO II Design: A Quantum Limited Interferometer for LIGO
of design The basic optical configuration is a power-recycled and signal-recycled Michelson interferometer with Fabry-Perot ‘transducers’ in the arms. This requires the addition of a signal recycling mirror to the suspended optics at the output ‘dark’ port, and changes in the RF modulation and control systems. The control system relies on a hierarchy of actuators in the seismic and suspension s...
متن کاملExperimental test of an alignment-sensing scheme for a gravitational-wave interferometer.
An alignment-sensing scheme for all significant angular degrees of freedom of a power-recycled Michelson interferometer with Fabry-Perot cavities in the arms was tested on a tabletop interferometer. The response to misalignment of all degrees of freedom was measured at each sensor, and good agreement was found between measured and theoretical values.
متن کاملAnalysis of light noise sources in a recycled Michelson interferometer with Fabry-Perot arms.
We present a method by which the effect of laser field variations on the signal output of an interferometric gravitational wave detector is rigorously determined. Using the Laser Interferometer Gravitational Wave Observatory (LIGO) optical configuration of a power recycled Michelson interferometer with Fabry-Perot arm cavities as an example, we calculate the excess noise after the input filter ...
متن کاملThe Comparison of Environmental Effects on Michelson and Fabry-Perot Interferometers Utilized for the Displacement Measurement
The optical structure of general commercial interferometers, e.g., the Michelson interferometers, is based on a non-common optical path. Such interferometers suffer from environmental effects because of the different phase changes induced in different optical paths and consequently the measurement precision will be significantly influenced by tiny variations of the environmental conditions. Fab...
متن کاملHigh-gain power recycling of a Fabry-Perot Michelson interferometer for a gravitational-wave antenna.
Power recycling was implemented on a fully suspended prototype interferometer with arm lengths of 20 m. A wave-front-sensing technique for alignment control of the suspended mirrors was also implemented, which allowed for several hours of stable operation. A power-recycling gain of greater than 12 was achieved, a significant increase over the highest gain in a suspended mirror Fabry-Perot Miche...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Optics letters
دوره 20 13 شماره
صفحات -
تاریخ انتشار 1995