The use of multi-electrode resistivity imaging in gravel prospecting

We investigated the potential of using a 24-electrode resistivity imaging apparatus for rapid reconnaissance surveys for natural-aggregate accumulation. The surveys were first calibrated at sites with known geometry of sand and gravel layers, which showed that subsurface accumulation of coarse material was accurately resolved with both 2and 4-m electrode spacing. The inverted absolute resistivity of economically viable gravel deposits varied in the range of 300–1500 V m, depending on variation in ground-moisture levels. The exploration surveys were then conducted at seven sites where geomorphological analyses indicated a potential for gravel. Four of these sites, where subsurface resistivity did not exceed 30–40 V m, were found to have very little or no coarse material. The three remaining sites showed significant accumulations of high-resistivity material, two of which were subsequently augered for verification. The results of drilling demonstrated that resistivity images were an effective indicator of the presence of coarse material in the subsurface, allowing accurate determination of subsurface distribution and thickness of sand and gravel strata. The total volume of a deposit could easily be estimated from resistivity images. The absolute quality and economic value of the material, is, however, difficult to ascertain from resistivity images alone without drilling. D 2002 Elsevier Science B.V. All rights reserved.