Loop Gain Measurement
ثبت نشده
چکیده
منابع مشابه
Studying Dynamic behavior of Distributed Parameter Processes Behavior Based on Dominant Gain Concept and it’s Use in Controlling these Processes
In this paper, distributed parameter process systems behavior is studied in frequency domain. Based on the dominant gain concept that is developed for such studies, a method is presented to control distributed parameter process systems. By using dominant gain concept, the location of open loop zeros, resulted from the time delay parameter in the process model, were changed from the right half p...
متن کاملPreviously Unobserved Effects of Delay on Current-Mode Control
Abstract--A new sampled-data model for the current-mode controlled buck converter includes for the first time the effects of delay in the current loop. Modified z-transforms are used in this new model for constant frequency trailing-edge modulation. Realistic amounts of delay are found to be particularly significant when the buck converter is operating in the continuous conduction mode near the...
متن کاملA Closed Loop Control of Quadratic Boost Converter Using PID Controller
This paper presents an implementation of open loop and closed loop control of Quadratic boost converter using PID controller. Quadratic boost converter consists of boost converter and fly back converter driven by a single switch. Quadratic boost converter QBC is designed especially for regulating the DC interface between various micro sources and dc-ac inverter to electricity grid. Quadratic b...
متن کاملA Test Methodology to Measure the Open-Loop Voltage Gain of an Operational Amplifier
It is practically not feasible to measure the open-loop voltage gain of the operational amplifier in the open loop configuration. It is because the open-loop voltage gain of the operational amplifier is very large. In order to avoid the saturation of the output voltage, a very small input should be given to operational amplifier which is not possible to be measured practically by a digital mult...
متن کاملEvaluation of the design requirements for the electrical part of transmission-type optical smoke detector to improve its threshold stability to slowly varying influences
The output signal sensitivity to optical component contamination and other slowly varying parasitic influences in the transmission-type smoke detector is analyzed. The analysis carried out the new topology characterized by the selective feedback loop incorporating the optical part of the detector. Depending on the loop gain frequency shaping in the electrical part of the loop, dual stability en...
متن کامل