Practical considerations on the use of down-sized time-domain reflectometry (TDR) probes

Nine time-domain reflectometry (TDR) probes, 2 to 10 cm long, were evaluated by comparing their measurement accuracy of TDR-pulse travel time in a sand and sandy loam soil, and electrical conductivity in NaCl solutions. TDR probes <2.5 cm in length generated troughhaped TDR waveforms with rounded corners at the points of the pulse reflection from the probe ends. The sharpness of the pulse reflection on the waveforms increased with both the increasing probe length and soil-water content. The transition time for the propagation of TDR pulse at the probe entrance increased as the soil dried up. The increased transition time caused a rightward movement of the first peak of the waveform at the probe entrance. Because of such peak movement, TDR-support software algorithm determined travel path of TDR pulse through the probe that was smaller than the actual travel path. TDR-measured pulse travel time tTDR varied erratically with the predicted pulse travel time tg (from volumetric soil-water content) for the probes <2.5 cm in length. But, for all probes 32.5 cm in length, tTDR varied linearly with tg and followed the 1:1 line. TDR could not measure tTDR < 300 ps accurately. A minimum probe length Lmin and the lowest allowable soilwater content qmin that the probe can accurately measure govern this lowest pulse travel time tmin. The mean absolute deviation between tTDR and tg was 77 ps for the 2.3 cm long probe and 1.39 ps for all probes ≥2.5 cm in length. All probes ≥2.5 cm in length measured electrical conductivity of salt solutions sTDR that compared well with the electrical conductivity measured by a conductivity meter sm. The length of the probes did not exert any noticeable influence on the accuracy of electrical conductivity measurement.