Understanding the influence of alendronate on the morphology and phase transformation of apatitic precursor nanocrystals.

نویسندگان

  • Guiling Zhang
  • Rong Huang
  • Zhicheng Li
  • Xianyan Yang
  • Xiaoyi Chen
  • Wei Xia
  • Xiaoliang Sun
  • Guojing Yang
  • Changyou Gao
  • Zhongru Gou
چکیده

Bisphosphonates (BPs) are a class of synthetic pyrophosphate analogs that can prevent the loss of bone mass, given orally to treat postmenopuasal osteoporosis. It is not clear yet if the benefits of BPs include the possibility of affecting bone apatitic precursors transition for bone consolidation except for encouraging osteoclasts to undergo apoptosis. Furthermore, the complexity of the in vivo system makes it difficult to isolate and study such extracellular topographical cues that trigger bone turnover response. Herein, we proposed a wet-chemical approach employing alendronate sodium (AS) as a guide of hydroxyapatite (HA) precursor growth and conversion which was initiated from the nucleantion of octacalcium phosphate (OCP) in a cell membrane-mimicking surfactant micelle aqueous system. The nanocrystal clusters of dicalcium phosphate dihydrate (DCPD) and OCP nanocryatals were readily precipitated within a relatively narrow AS concentration range (2-8 μM). However, such low concentrations of AS seemed to stabilize the more acidic phases, and to delay the transformation into HA, to an extent which increased on increasing AS concentration. In contrast, at a slight higher concentrations (16-32 μM), AS promoted HA precipitation after ageing for 1h. It was found that the effect of AS on the phase selectivity of apatitic precursors was concentration-dependent within a prolonged ageing time stage (0.5-168 h). The AS-assisted reactions in vitro offer an expedient way to understand the underlying implementarity between bone and BPs for bone consolidation, and to improve our understanding of benefit of BP dosages on bone turnover and trauma healing.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Nitric acid on Particle Morphology of the Nano-TiO2

Nano-sized titanium dioxide TiO2 powder was prepared by new wet chemical route from its precursor Titanium (IV) chloride (TiCl4) as precursor with isopropoxy alcohol in presence of nitric acid under ambient condition. Their morphologies, phase compositions and components of the TiO2 nanoparticles were characterized by transmission electron ...

متن کامل

Fabrication and Characterization of Rutile TiO2 Nanocrystals by Water Soluble Precursor

      In this research, TiO2 nanoparticles were synthesized by a simple wet chemical method. TiCl4 was used as precursor in hydrogen peroxideand ethanol. The TiO2 nanoparticles were characterized by transmission electron microscopy (TEM), scanning electron microscopy (SEM), X-ray diffraction (XRD), electron dispersive spectroscopy (EDS) and UV-Vis spectrophotome...

متن کامل

Study on Structural and Optical Properties ‎of Wurtzite Cu2ZnSnS4 Nanocrystals ‎Synthesized via Solvothermal Method

   A simple low-cost solvothermal method was applied to synthesize hexagonal wurtzite Cu2ZnSnS4 (CZTS) nanoparticles with different morphologies using Polyvinylpyrrolidone (PVP) as a capping ligand and copper and zinc acetate salts at 180 and 220 ℃. The resulting sphere-like and flower-like nanoparticles synthesized at 180 and 220℃</...

متن کامل

Influence of Calcination Kinetics Parameters on Synthesis of KNN Piezoelectric Ceramics

The current research was focused on synthesizing potassium sodium niobate (KNN) piezoelectric ceramics for the system (K0.48Na0.52) NbO3   by high energy ball milling process for 15h at the speed of 300 rpm.  The blended nano-crystalline powder was calcined in conventional box furnace at 700oC, 800oC and 900oC for duration of 5h, 7h and 10h.  Diffraction result of calcine powder confirmed the f...

متن کامل

Characterization and Phase Transformation of Spherical YSZ Powders Fabricated Via air Plasma Spray Method

Air plasma spray (APS) process is used to produce high density and flowability spherical powders. Phase transformation that occurred in this process isn’t well known. In this paper, the YSZ powders have been sprayed in water to investigate the morphology changes and phase transformations via air plasma spray (APS) method. Phase analysis of powders was examined by XRD and the crystallite size an...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Journal of inorganic biochemistry

دوره 113  شماره 

صفحات  -

تاریخ انتشار 2012