Dentinoenamel Junction as a Model for Dentin Bonding Optimization

The purpose of this article is to review evidence-based principles that could help optimize dentin bonding for indirect composite and porcelain restorations. More than 30 articles were reviewed, most of them addressing the specific situation of dentin bonding for indirect restorations. It appears that the combined results of this data plus clinical experience suggest the need for a revision in the dentin bonding procedure. Immediate application and polymerization of the dentin bonding agent to the freshly cut dentin, prior to impression taking, is recommended. This new application procedure, the so-called immediate dentin sealing (IDS), appears to achieve improved bond strength, fewer gap formations, decreased bacterial leakage, and reduced dentin sensitivity. The use of filled adhesive resins (low elastic modulus liner) facilitates the clinical and technical aspects of IDS. This rational approach to adhesion also has a positive influence on tooth structure preservation, patient comfort, and long-term survival of indirect bonded restorations. CLINICAL SIGNIFICANCE Tooth preparation for indirect bonded restorations (eg, composite/ceramic inlays, onlays, and veneers) can generate significant dentin exposures. It is recommended to seal these freshly cut dentin surfaces with a dentin bonding agent (DBA) immediately following tooth preparation, before taking impression. A three-step total-etch DBA with a filled adhesive resin is recommended for this specific purpose. The major advantages, as well as the technical challenges of this procedure, are presented in detail. (J Esthet Restor Dent 17:144–155, 2005)