Correlation between knee kinematics and patellofemoral contact pressure in total knee arthroplasty.

نویسندگان

  • Takuya Konno
  • Tomohiro Onodera
  • Yusuke Nishio
  • Yasuhiko Kasahara
  • Norimasa Iwasaki
  • Tokifumi Majima
چکیده

The aim of this study is to evaluate the relationship between patellofemoral contact stress and intraoperative knee kinematic patterns after mobile bearing total knee arthroplasty (TKA). Medial osteoarthritic knees of forty-six posterior-stabilized total knee prostheses were evaluated using a computed tomography-guided navigation system. Subjects were divided into two groups based on intraoperative knee kinematic patterns: the medial pivot group (n=19) and the non-medial pivot group (n=27). Mean intraoperative patello-femoral contact stress was significantly lower in the medial pivot group than in the non-medial pivot group (1.7MPa vs. 3.2MPa, P<0.05). An intraoperative medial pivot pattern results in reduced patello-femoral contact stress.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Biomechanical effects of kneeling after total knee arthroplasty.

BACKGROUND Kneeling following total knee arthroplasty can be a difficult task, impairing the activities of patients to varying degrees. Little is known about the biomechanical effects of kneeling following total knee replacement. The objective of this study was to quantify the effects of kneeling on patellofemoral joint contact areas and pressures, knee joint reaction force, and patellar kinema...

متن کامل

Effects of patellar resurfacing on contact area and contact stress in total knee arthroplasty.

The objective of this study was to examine the effects of patellar resurfacing on patellofemoral joint contact pressure and contact area in total knee arthroplasty. We tested seven fresh-frozen cadaveric knees using a custom knee jig which permits the simulation of physiologic quadriceps loading. Before patellar resurfacing, the mean peak contact pressure of medial and lateral patellofemoral jo...

متن کامل

Influence of Different Patellofemoral Design Variations Based on Genesis II Total Knee Endoprosthesis on Patellofemoral Pressure and Kinematics

In total knee arthroplasty (TKA), patellofemoral groove design varies greatly and likely has a distinct influence on patellofemoral biomechanics. To analyse the selective influence, five patellofemoral design variations were developed based on Genesis II total knee endoprosthesis (original design, being completely flat, being laterally elevated, being medially elevated, and both sides elevated)...

متن کامل

Biomechanics of Hyperflexion and Kneeling before and after Total Knee Arthroplasty

The capacity to perform certain activities is frequently compromised after total knee arthroplasty (TKA) due to a functional decline resulting from decreased range of motion and a diminished ability to kneel. In this manuscript, the current biomechanical understanding of hyperflexion and kneeling before and after TKA will be discussed. Patellofemoral and tibiofemoral joint contact area, contact...

متن کامل

Kinematic alignment produces near-normal knee motion but increases contact stress after total knee arthroplasty: A case study on a single implant design.

BACKGROUND Kinematically aligned total knee arthroplasty (TKA) is of increasing interest because this method might improve postoperative patient satisfaction. In kinematic alignment the femoral component is implanted in a slightly more valgus and internally rotated position, and the tibial component is implanted in a slightly more varus and internally rotated position, than in mechanical alignm...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Journal of arthroplasty

دوره 29 12  شماره 

صفحات  -

تاریخ انتشار 2014