Local relative density modulates failure and strength in vertically aligned carbon nanotubes.

نویسندگان

  • Siddhartha Pathak
  • Nisha Mohan
  • Elizabeth Decolvenaere
  • Alan Needleman
  • Mostafa Bedewy
  • A John Hart
  • Julia R Greer
چکیده

Micromechanical experiments, image analysis, and theoretical modeling revealed that local failure events and compressive stresses of vertically aligned carbon nanotubes (VACNTs) were uniquely linked to relative density gradients. Edge detection analysis of systematically obtained scanning electron micrographs was used to quantify a microstructural figure-of-merit related to relative local density along VACNT heights. Sequential bottom-to-top buckling and hardening in stress-strain response were observed in samples with smaller relative density at the bottom. When density gradient was insubstantial or reversed, bottom regions always buckled last, and a flat stress plateau was obtained. These findings were consistent with predictions of a 2D material model based on a viscoplastic solid with plastic non-normality and a hardening-softening-hardening plastic flow relation. The hardening slope in compression generated by the model was directly related to the stiffness gradient along the sample height, and hence to the local relative density. These results demonstrate that a microstructural figure-of-merit, the effective relative density, can be used to quantify and predict the mechanical response.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Optimized Conditions for Catalytic Chemical Vapor Deposition of Vertically Aligned Carbon Nanotubes

Here, we have synthesized vertically aligned carbon nanotubes (VA-CNTs), using chemical vapor deposition (CVD) method. Cobalt and ethanol are used as the catalyst and the carbon source, respectively. The effects of ethanol flow rate, thickness of Co catalyst film, and growth time on the properties of the carbon nanotube growth are investigated. The results show that the flow rate of ethanol and...

متن کامل

Controlled growth and modification of vertically-aligned carbon nanotubes for multifunctional applications

Vertically-aligned carbon nanotubes possess many advantages for a wide range of multifunctional applications. Along with the controlled growth of aligned/micropatterned carbon nanotubes, surface modification of vertically-aligned carbon nanotubes are essential in order to meet specific requirements demanded for particular applications. While many innovative synthetic methods have been developed...

متن کامل

Super-compressible foamlike carbon nanotube films.

We report that freestanding films of vertically aligned carbon nanotubes exhibit super-compressible foamlike behavior. Under compression, the nanotubes collectively form zigzag buckles that can fully unfold to their original length upon load release. Compared with conventional low-density flexible foams, the nanotube films show much higher compressive strength, recovery rate, and sag factor, an...

متن کامل

Diameter and morphology control of SWNTs by alcohol CVD

The concentration of Co-Mo binary catalyst concentration and the effect on the morphology of single-walled carbon nanotubes (SWNT) was investigated by scanning electron microscopy and optical spectroscopy. We found that there is some critical concentration or catalyst density below which SWNTs will not be vertically aligned. Higher Mo concentrations resulted in vertically aligned, small-diamete...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • ACS nano

دوره 7 10  شماره 

صفحات  -

تاریخ انتشار 2013