SAXS investigation of nanoporous structure of thermal-modified carbon materials

نویسندگان

  • Bogdan K Ostafiychuk
  • Volodymyr I Mandzyuk
  • Yuriy O Kulyk
  • Nadiia I Nagirna
چکیده

UNLABELLED The article investigates the effect of thermal modification of porous carbon material (PCM), obtained from plant feedstock, on its morphology and fractal structure by small-angle X-ray scattering (SAXS) method. The analysis of the scattering intensity curves serve the basis for calculating the parameters of the PCM porous structure: the Porod constant, the Porod invariant, average pore radius, specific surface area, and mass and surface fractal dimensions. It has been found out that the PCMs obtained have fractal structure, formed from mass and surface fractals, the sizes of which increase at the growth of temperature and modification time. PACS 81.05.Uw; 61.05.cf; 82.47.Aa.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Stepwise Synthesis of Mesoporous Carbon Nitride Functionalized by Melamine Based Dendrimer Amines for Adsorption of CO2 and CH4

In this study, a novel solid dendrimer amine (hyperbranched polymers) was prepared using mesoporous carbon nitride functionalized by melamine based dendrimer amines. This adsorbent was denoted MDA-MCN-1. The process was stepwise synthesis and hard-templating method using mesoporous silica SBA-15 as a template. Cyanuric chloride and N,N-diisopropylethylamine (DIPEA, Merck) were used for function...

متن کامل

Synthesis and Characterization of Amine-modified Mesoporous SBA-15 for Carbon Dioxide Sequestration at High Pressure and Room Temperature (RESEARCH NOTE)

Amine-modified mesoporous SBA-15 adsorbent has been prepared by impregnation method using tetraethylenepentamine. The samples of this modified SBA-15 have been characterized by small angle X-ray scattering (SAXS), Scanning electron microscopy (SEM), Nitrogen adsorption-desorption isotherm and FT-IR. The adsorption capacity of CO2 on unmodified and modified samples were measured at high pressure...

متن کامل

Modified Nanoporous Carbon Material for Anionic Dye Removal from Aqueous Solution

In this study, the adsorption behavior of anionic dyes from aqueous solution onto mesoporous carbon material (CMK-1) and modified with polymer (PANI/CMK-1) has been investigated as a function of parameters such as adsorbent dose (0.08-0.8 g/L), solution pH 3–10, contact time and initial concentration (10-100 mg/L). The influence of these parameters on the adsorption capacity has been studied us...

متن کامل

Synthesis of Ethylenediamine-modified Ordered Mesoporous Carbon as a New Nanoporous Adsorbent for Removal of Cu(II) and Pb(II) Ions from Aqueous Media

The mesoporous carbon (CMK-3) functionalized with ethylenediamine (EDA) has been synthesized (CMK-3-EDA) and applied as a new mesoporous adsorbent for removal of Cu(II) and Pb(II) cations from aqueous solutions. Nitrogen adsorption–desorption measurements (BET) show that surface area, pore size and pore volume of CMK-3 were significantly changed after amine modification. The BET surface area an...

متن کامل

Supercritical CO2 Extraction of Porogen Phase: An Alternative Route to Nanoporous Dielectrics

We present a supercritical CO 2 (SCCO 2) process for the preparation of nanoporous organosilicate thin films for ultra low dielectric constant materials. The porous structure was generated by SCCO 2 extraction of a sacrificial poly(propylene glycol) (PPG) from a nanohybrid film, where the nanoscopic domains of PPG porogen are entrapped within the crosslinked poly(methylsilsesquioxane) (PMSSQ) m...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 9  شماره 

صفحات  -

تاریخ انتشار 2014