Statistical Analysis of the V-tool Bending Process Parameters in the Bending of Hc260y Steel
نویسندگان
چکیده
J. Cumin, I. Samardžić, L. Maglić. Mechanical Engineering Faculty, J.J. Strossmayer University of Osijek, Slavonski brod, Croatia. This paper presents statistical analysis of the parameters in the V-tool bending process of the HC260Y steel. Assessment of the mathematical model and analysis of variance (ANOVA) were performed within the design of experiments. The hydraulic testing machine Amsler and the developed V-tool were used in the experiments.
منابع مشابه
Numerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کاملU-Bending Analysis with an Emphasis on Influence of Hardening Models
In this paper the effect of different hardening models in simulating the U-bending process for AA5754-O and DP-Steel, taking a benchmark of NUMISHEET 93 2-D draw bending, has been discussed. The hardening models considered in simulations are: isotropic hardening, pure (linear) kinematic hardening and combined (nonlinear kinematic) hardening. The influence of hardening models on predicting sprin...
متن کاملHealth Monitoring of Welded Steel Pipes by Vibration Analysis
In the present work, structure health monitoring (SHM) of welded steel pipes was used to diagnosis their state via vibration based damage detection techniques. The dynamic quantities such as Frequency Response Functions (FRFs), mode shapes and modal parameters from structural vibration to detect damage were measured, set on linear averaging mode, with a maximum frequency of analysis of 3.2 kHz....
متن کاملEffect of Spring-back in V-tool Bending of High-strength Steel Sheet Metal Plates
B. Grizelj, J. Cumin, Mechanical engineering Faculty in Slavonski Brod, Slavonski Brod, Croatia D. Grizelj, Siemens, Zagreb, Croatia. This paper deals with the eff ects of technological parameters used in the V-die bending process, on the obtained product properties and dimensions. By variation of the tool geometry, several cases of steel sheet bending process are observed through the FEM simul...
متن کاملEXPERIMENTAL AND NUMERICAL INVESTIGATION ON LASER BENDING PROCESS
Laser bending is an advanced process in sheet metal forming in which a laser heat source is used to shape the metal sheet. In this paper, temperature distribution in a mild steel sheet metal is investigated numerically and experimentally. Laser heat source is applied through curved paths in square sheet metal parts. Finite element (FE) simulation is performed with the ABAQUS/CAE standard softwa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015