RF performances of inductors integrated on localized p+-type porous silicon regions
نویسندگان
چکیده
To study the influence of localized porous silicon regions on radiofrequency performances of passive devices, inductors were integrated on localized porous silicon regions, full porous silicon sheet, bulk silicon and glass substrates. In this work, a novel strong, resistant fluoropolymer mask is introduced to localize the porous silicon on the silicon wafer. Then, the quality factors and resonant frequencies obtained with the different substrates are presented. A first comparison is done between the performances of inductors integrated on same-thickness localized and full porous silicon sheet layers. The effect of the silicon regions in the decrease of performances of localized porous silicon is discussed. Then, the study shows that the localized porous silicon substrate significantly reduces losses in comparison with high-resistivity silicon or highly doped silicon bulks. These results are promising for the integration of both passive and active devices on the same silicon/porous silicon hybrid substrate.
منابع مشابه
Chip-level integration of RF MEMS on-chip inductors using UV-LIGA technique
This paper presents a chip-level integration of radio-frequency (RF) microelectromechanical systems (MEMS) air-suspended circular spiral on-chip inductors onto MOSIS RF circuit chips of LNA and VCO using a multi-layer UV-LIGA technique including SU-8 UV lithography and copper electroplating. A high frequency simulation package, HFSS, was used to determine the layout of MEMS on-chip inductors wi...
متن کاملFabrication of RF MEMS Components on CMOS Circuits
Recently deep submicron and SiGe (silicongermanium) bipolar CMOS technologies have enhanced the performance of Si-based radio frequency (RF) integrated circuits up to microwave frequencies. The integration of RF MEMS components, such as inductors and capacitors, could further improve the performance of key RF circuit blocks such as voltage controlled oscillators (VCO), low-noise amplifiers, fil...
متن کاملInfluence of current density on refractive index of p-type nanocrystalline porous silicon
Porous Silicon (PS) layers have been prepared from p-type silicon wafers of (100) orientation. SEM, XRD, FTIR and PL studies were done to characterize the surface morphological and optical properties of PS. The porosity of the PS samples was determined using the parameters obtained from SEM images by geometric method. The refractive index values of the PS samples as a function of poros...
متن کاملInfluence of current density on refractive index of p-type nanocrystalline porous silicon
Porous Silicon (PS) layers have been prepared from p-type silicon wafers of (100) orientation. SEM, XRD, FTIR and PL studies were done to characterize the surface morphological and optical properties of PS. The porosity of the PS samples was determined using the parameters obtained from SEM images by geometric method. The refractive index values of the PS samples as a function of poros...
متن کاملSystematic Analysis and Modeling of Integrated Inductors and Transformers in RF IC Design
An efficient modeling technique and a novel CAD tool for the accurate prediction of the performance of integrated inductors and transformers is presented. This generic and process-independent approach generates lumped-element models that easily plug into the RF IC design flow. Their accuracy is established through comparisons with measurements of numerous fabricated inductor structures. This pa...
متن کامل