Excitation of a Longitudinal Slot on a Hollow Rectangular Coaxial Line by Metal Support of the Inner Conductor
نویسندگان
چکیده
This paper presents the excitation of a longitudinal slot on a hollow rectangular coaxial line by a metal support between two conductors and the fabrication by diffusion bonding of laminated metal thin plates. The measured loss of a straight line is 0.046dB/cm at 60GHz while the simulated one is 0.043dB/cm.
منابع مشابه
Design of a Corporate-fed 2×2-element Slot Array on a Hollow Rectangular Coaxial Line
In order to realize a single-layer corporate-fed slot array, a hollow rectangular coaxial line is adopted as a feeding line. A 2×2-element subarray on a hollow rectangular coaxial line for the corporate-fed array is designed for the 60-GHz band. For the wideband operation, a cavity-backed wide slot is adopted as a radiating element. The 5.7% bandwidth for the reflection less than −20 dB is obta...
متن کاملDesign of Microfabricated Rectangular Coaxial Lines and Components for mm-Wave Applications
Miniature 310μm tall copper-air rectangular coaxial lines (RCL) with the inner conductor supported by periodic dielectric straps are demonstrated in this paper. The measured line loss is about 0.2dB/cm at 26GHz, while the isolation between two parallel lines with a center-to-center separation of 700μm is better than 60dB. Several quasi-planar components are designed and fabricated on the same w...
متن کاملDesign, simulation and Fabrication of Circularly Polarized Fabry-Perot Antenna for Ku Band
This paper deals with the design and simulation of a RHCP Fabry-Perot antenna for 14.5 GHz. Based on transmission line model, partially Reflecting Surface (PRS) was designed so thatgain enhancement and circular polarization simultaneously obtained. PRS consist of a square loop and meander-line at the top and bottom respectively. In order to achieve the resonance condition in orthogonal componen...
متن کاملAnalytic and Numerical Analysis of the Longitudinal Coupling Impedance of an Annular Cut in a Coaxial Liner
Beam pipes of high-energy superconducting colliders require a shielding tube (liner) with pumping slots to screen cold chamber walls from synchrotron radiation. Pumping slots in the liner walls are required to keep high vacuum inside the beam pipe and provide for a long beam lifetime. As previously discussed [Fedotov and Gluckstern, Phys. Rev. E 54, 1930 (1996)], for a long narrow slot whose le...
متن کاملModeling, Design, Fabrication, and Performance of Rectangular g-Coaxial Lines and Components
A miniature non-uniform copper-air rectangular coaxial line with the inner conductor supported by periodic dielectric straps is demonstrated. The overall height of the line is 310gm with the outer conductor cross-section being 250gmx250gm. The measured loss is 0.22dB/cm at 26GHz, while the isolation between two parallel lines with a center-to-center separation of 700gm is better than 60dB. Seve...
متن کامل