A guarded switching system for automatic selection of high value resistors under calibration
نویسندگان
چکیده
At IEN, a guarded switching system for automatic selection of high value resistors under calibration was developed and metrologically characterized. By means of this system it is possible to select and connect to the measurement system [1, 2] high value resistors in three terminals configuration. As a matter of fact, its guard system allows to reduce the effects due to all the dispersion currents, due to insulation resistances between the resistors under calibration and their shields and due to the switching and connection system (such as insulation resistances among connections, of cables and connectors used for resistors connections). This system utilizes some details of the device described in [6, 7]. The uncertainties that can be reached with the measurement system in connection with the scanner in the calibration of high value resistors and a compatibility test of measurement performed with and without the scanner, are also given.
منابع مشابه
10, ×, 10 𝔾Ω Guarded Hamon Network for the Modified Wheatstone Bridge for High Value Resistors Calibration
At the National Institute of Metrological Research (INRIM), a Hamon guarded 10×100 M network was developed to improve the traceability levels of dc resistance at 1 G level. Utilizing and revisiting this project, a Hamon 10×10 G network is developed to extend the capabilities of the Hamon scaling technique up to 100 G . The novelty of the 10× 10 G network is its improved guard system, and the im...
متن کاملEstimation and Calibration of Robot Link Parameters with Intelligent Techniques
Abstract: Using robot manipulators for high accuracy applications require precise value of the kinematics parameters. Since measurement of kinematics parameters are usually associated with errors and accurate measurement of them is an expensive task, automatic calibration of robot link parameters makes the task of kinematics parameters determination much easier. In this paper a simple and easy ...
متن کاملAn Optimal Selection of Induction Heating Capacitance by Genetic Algorithm Considering Dissipation Loss Caused by ESR (TECHNICAL NOTE)
In design of a parallel resonant induction heating system, choosing a proper capacitancefor the resonant circuit is quite important. The capacitance affects the resonant frequency, outputpower, Q-factor, heating efficiency and power factor. In this paper, the role of equivalent seriesresistance (ESR) in the choice of capacitance is significantly recognized. Optimal value of resonancecapacitor i...
متن کاملAn Automatic Dc Current Comparator Resistance Bridge
The principle of the Direct Current Comparator has been around for some 30 years, however, very little work has been done towards automation. This paper describes a bridge for measuring resistance ratios in the range of 0.001 ohms to 10,000 ohms using a microprocessor controlled automated DC Current Comparator with IEEE-488 to an uncertainty of better than 0.1 ppm from 1 ohm to 1000 ohms and 0....
متن کاملModeling and Efficient Control of Microturbine Generation System With Battery Energy Storage for Sensitive Loads
Microturbine generation system is one of the most promising and a fast growing distributed generation sources. It is used in various applications thanks to high efficiency, quick start and high reliability. Combination of the microturbine and storage system (e.g. battery bank) is desirable selection to satisfy the load requirements under all conditions and hence the battery bank can play an imp...
متن کامل