Preliminary Design of a Perpendicular Biased Ferrite Loaded Accelerating Cavity
نویسندگان
چکیده
A ferrite loaded accelerating cavity with a frequency sweep of 18 to 40MHz is studied for a possible upgrade of the CERN accelerator complex. The resonance frequency of a ferrite loaded cavity shifts by applying an external magnetic bias field to the ferrite material by means of changing the relative permeability. We present the electromagnetic design of such a cavity with a special emphasis on the modeling of the nonlinear, anisotropic and dispersive characteristics of the ferrite’s relative permeability above magnetic saturation. For experimental crosscheck, a ferrite loaded resonant test setup was built which provides results for the material performance in a magnetic bias field. A comparison of numerical simulations and experimental measurements is shown and calculations are benchmarked by measurement data. Based on this study a preliminary design of a ferrite loaded accelerating cavity is described.
منابع مشابه
Ferrite Material Characterization in a Static Bias Field for the Design of a Tuneable Cavity
During the development of ferrite-loaded accelerating cavities, the electromagnetic properties of the dispersive ferrite material need to be known. We describe a coaxial short-circuit measurement technique to measure the complex permeability of toroidal-shaped samples (127mm outer and 70mm inner diameter) that are exposed to an external magnetic bias field. The external magnetic bias field is a...
متن کاملThe Ipns Rcs Rf System Third Cavity Upgrade*
The IPNS RCS is a rapid cycling synchrotron used to accelerate protons from 50 MeV to 450 MeV, 30 times per second. Currently, two single-gap, ferrite-loaded coaxial cavities, located 180o apart, provide a total peak accelerating voltage of approximately 21 kV over the 2.2 MHz to 5.1 MHz revolution frequency band. An amplifier chain, which includes a 2 kW predriver, a 20 kW driver and a 100 kW ...
متن کاملEffective Radiation Efficiency of Resistor-Loaded Bow-Tie Antenna Covered with Ferrite-Coated Conducting Cavity Located above Ground Surface
This paper analyzes the effective radiation efficiency of a ground-penetrating radar (GPR) consisting of two resistor-loaded bow-tie antennas covered with a ferrite-coated conducting cavity by using finite-difference time-domain (FDTD) method. The GPR is located above a lossless or lossy ground surface. The relation between the radiation powers into the ground and air, dissipated powers at the ...
متن کاملA Superconducting Landau Accelerator Module for Bessy Ii
The installation of a 3rd harmonic Landau accelerator module is planned at BESSY II to improve the beam lifetime. The passive cavity shall provide an accelerating voltage up to 500 kV for beam currents from 10 to 500 mA. A CESR Phase-III cavity [1], scaled to 1.5 GHz, will be used. The cavity design provides strong damping of higher-order modes by ferrite loads on the beam tubes. A new module, ...
متن کاملFast Rf Ferrite Phase Shifter for High-power Applications
Fast rf phase shifters may be needed, in powering a superconducting linac, between rf generators and accelerating cavities when one klystron feeds more than one cavity. The configuration with one klystron for many cavities needs orthogonal controls of magnitude and phase of rf power in order to preserve system performance while reducing construction cost. For this reason, a waveguide ferrite ph...
متن کامل