Analysis of the shape of dendrimers under shear.

نویسندگان

  • Jaroslaw T Bosko
  • B D Todd
  • Richard J Sadus
چکیده

Nonequilibrium molecular-dynamics simulations are used to investigate the molecular shape of dendrimers and linear polymers in a melt and under shear. Molecules are modeled at the coarse-grained level using a finitely extensible nonlinear elastic bead-spring model. The shape of dendrimers and linear polymers at equilibrium and undergoing planar Couette flow is analyzed quantitatively and it is related to the shear viscosity. The shape of dendrimers responds differently to the influence of shear compared with linear polymers of equivalent molecular mass. However, in both cases the transition from Newtonian to non-Newtonian viscosity behavior corresponds to significant changes in molecular symmetry. This suggests that a shape analysis could be used to estimate the onset of shear thinning in polymers.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Analysis of Axisymmetric Extrusion Process through Dies of any Shape with General Shear Boundaries

In this paper, a generalized expression for the flow field in axisymmetric extrusion process is suggested to be valid for any dies and the boundary shapes of the plastic deformation zone. The general power terms are derived and the extrusion force is calculated by applying upper bound technique for a streamlined die shape and exponential functions for shear boundaries. It is shown that assuming...

متن کامل

Improving Cyclic Behavior of Steel Plate Shear Walls with Elliptical Perforations

In this paper, the effect of elliptical shape openings was numerically compared to the case when circular openings were used in the steel panel shear walls. At first, the finite element model in ABAQUS was calibrated by experimental results, obtained from previous studies. Then, three steel shear panels with different sizes of elliptical openings were analyzed under cyclic loads, and the result...

متن کامل

Effect of type and distribution of shear studs on the behavior of composite steel-concrete shear walls

In this research in-plane shear Behavior of composite steel-concrete shear walls was investigated considering the Effects of steel plates thickness, spaces between shear studs, shape and type of shear studs and existing of minimum reinforcement in wall section. Several finite element models were analyzed and Numerical results of two models were taken under verification with existent experimenta...

متن کامل

Deformation flow analysis and symmetry of Goushti shear zone, Sanandaj-Sirjan metamorphic belt, Iran

Finite strain and vorticity analyses were carried out in the deformed conglomerate and micro-conglomerate of Goushti shear zone in the Sanandaj-Sirjan metamorphic belt (Zagros Mountains Iran). These deformed rocks are bounded between two NE and SW major thrust faults. Finite strain measurements on three principal planes of strain ellipsoid show the higher amounts of strain ratios near the major...

متن کامل

A Macro-model for Nonlinear Analysis of 3D Reinforced Concrete Shear Walls

Architectural limitations in many situations make it necessary for the RC shear walls to be extended in plan in different directions at a single location that makes them a 3D configuration. Analysis of such walls is very challenging. In this research about 450 cases of 3D shear walls are considered with different shapes and heights. L, T and H-shape walls are studied. They are nonlinearly analy...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Journal of chemical physics

دوره 124 4  شماره 

صفحات  -

تاریخ انتشار 2006