Flaw Simulation in Product Radiographs
نویسندگان
چکیده
منابع مشابه
Electronic reference images for flaw indications in welds and castings
Since decades the evaluation of flaw indications on radiographs from welds or castings are based on well accepted reference film catalogues from organizations like IIW (weldments), ASTM (castings) or DGZfP (D5 recommendation on heavy steel castings). Today, the transformation of classical film radiography to the digital world is in full progress. Some ASTM standards do not permit the evaluation...
متن کاملFatigue Life Prediction of Rivet Joints
Strength reduction in structures like an aircraft could be resulted as cyclic loads over a period of time and is an important factor for structural life prediction. Service loads are emphasized at the regions of stress concentration, mostly at the connection of components. The initial flaw prompting the service life was expected by using the Equivalent Initial Flaw Size (EIFS) which has been re...
متن کاملA new Algorithm for Flaw Simulation in Castings by Superimposing Projections of 3D Models onto X-Ray Images
In order to evaluate the sensitivity of defect inspection systems, it is convenient to examine simulated data. This gives the possibility to tune the parameters of the inspection method and to test the performance of the system in critical cases. In this paper, a simple method for the simulation of defects in radioscopic images of aluminum castings is presented. The approach simulates only the ...
متن کاملA Flaw Sizing Technique for Austenitic Stainless Steel Welds Using Creeping Wave Probe
One of the most important subjects in nuclear power plants is sizing of flaws which are detected during InService Inspection (ISI), since reliability of flaw sizing is very important to estimate the life of the structure or pressure equipment. The most difficult matter for applying the flaw sizing techniques mentioned above is how to identify the flaw tip signal, especially in the case of natur...
متن کاملSimulation based optimization of multi-product supply chain under a JIT system
It is scientifically challenging to determine the inventory level all through the supply chain in such a way that the desired objectives such as effectiveness and responsiveness of the supply chain system can be obtained. Simulation is a means for solving various problems which cannot be solved by regular exact models such as mathematical ones due to their complexity. The present paper is aime...
متن کامل