Design of Current Mode Interconnect Receiver Subsystem for High Performance Applications
نویسندگان
چکیده
A receiver subsystem for current mode interconnects is presented in the present paper. It is shown that current mode interconnects shows better performance compared to voltage mode interconnect circuits. The current mode interconnect system using proposed receiver subsystem shows about 15% lesser latency and 40% increased throughput. Effect of voltage scaling on power dissipation for current mode (CM) and voltage mode (VM) has been analyzed. Current mode interconnects shows lesser power dissipation compared to voltage mode circuits. Analysis has been carried out using SPICE in 0.18 μm technology.
منابع مشابه
Design of High Gain, High Reverse Isolation and High Input Matched Narrowband LNA for GPS L1 Band Applications Using 0.18µm Technology
Design of Global Positioning System (GPS) receiver with a low noise amplifier (LNA) in the front end remains a major design requirement for the success of modern day navigation and communication system. Any LNA is expected to meet the requirements like its ability to add the least amount of noise while providing sufficient gain, perfect input and output matching, and high linearity. However, mo...
متن کاملVoltage Regulation of a Negative Output Luo Converter Using a PD-PI Type Sliding Mode Current Controller
This paper describes a new design for direct sliding mode method with a high switching frequency using the PD-PI type sliding surface applied to a negative output Luo converter worked in continuous current mode for applications required constant power source such as aerospace applications, medical equipment and etc. Because of the output power and line changes, the converter model is also nonli...
متن کاملAn Ultra High CMRR Low Voltage Low Power Fully Differential Current Operational Amplifier (COA)
this paper presents a novel fully differential (FD) ultra high common mode rejection ratio (CMRR) current operational amplifier (COA) with very low input impedance. Its FD structure that attenuates common mode signals over all stages grants ultra high CMRR and power supply rejection ratio (PSRR) that makes it suitable for mixed mode and accurate applications. Its performance is verified by HSPI...
متن کاملPermanent Magnet DC Motor Sliding Mode Control System
In this paper a sliding mode controller (SMC) is designed for a permanent magnet direct current (PMDC) motor to enhance the motor performance in the presence of unwanted uncertainties. Both the electrical and mechanical signals are used as the inputs to the SMC. The complete motor control system is simulated on a personal computer with different design parameters and desirable system performanc...
متن کاملAn Interleaved Configuration of Modified KY Converter with High Conversion Ratio for Renewable Energy Applications; Design, Analysis and Implementation
In this paper, a new high efficiency, high step-up, non-isolated, interleaved DC-DC converter for renewable energy applications is presented. In the suggested topology, two modified step-up KY converters are interleaved to obtain a high conversion ratio without the use of coupled inductors. In comparison with the conventional interleaved DC-DC converters such as boost, buck-boost, SEPIC, ZETA a...
متن کامل