A 1.5V High-Gain High-Linearity Mixer Using CMOS gm Cell...
نویسندگان
چکیده
This paper describes a 1.5-V 2.4-GHz silicon down conversion mixer with a CMOS gm Cell using 0.35 um process [1]. With a 2.3-GHz local oscillator (LO) and a 2.4-GHz RF input, the mixer minimum double sideband noise figure (DSB NF) is 8.9 dB. The input third-order intercept point (IIP3) is 0.5 dBm, and the power conversion gain is 18 dB.
منابع مشابه
Design and Analysis of UWB Down-Conversion Mixer with Linearization Techniques
Frequency translation which converts the original signal to a much lower baseband frequency signal is a vital role in the RF receiver design. In this work, a high linear down-conversion Gilbert cell mixer at 100MHz is designed using TSMC 0.18μm RF CMOS process. Linearity is an important performance measure in RF circuits particularly in mixer design. In this paper, the two types of linearizatio...
متن کاملA 3–8GHz Broadband Low Power Mixer
A 3–8 GHz broadband mixer is presented in this paper. This broadband mixer is low power and high conversion gain. It provides current reuse and ac-coupled folded switching. This mixer is designed in TSMC 0.18-μm CMOS technology. This broadband mixer achieves simulated conversion gain of 9 ± 1.5 dB, a single sideband noise figure lower than 15.2 dB and IIP3 batter than −7 dBm. From 3–8GHz, at su...
متن کاملA 2.4 GHz High Performance CMOS Sub-Harmonic Mixer
In this paper a low power CMOS sub-harmonic mixer based on the Gilbert cell for 2.4 GHz ISM band application is presented, in which the position of the switching and transconductance stages of mixer has been exchanged. A tuning out inductor has been used between the RF and LO switching stages to improve the linearity and noise figure, and also to enhance the conversion gain of the Mixer. The ut...
متن کاملDesign of a high gain and highly linear common-gate UWB mixer in K-band
In this paper, in order to design a K-band commongate Gilbert-cell mixer via a 0.18 lm CMOS technology, thepNetwork and post-distortion cancellation (PDC) techniques are implemented simultaneously, resulting in the improvement of gain, bandwidth, noise figure and linearity. Also, a new method for implementing the p-Network, using the parasitic capacitances between RF and LO stage nodes, is prop...
متن کاملHarmonic Rejection in 2.4 GHz Gilbert Cell Mixer for Terrestrial Microwave Communication systems
Mixer is one of the significant components of the radio frequency transceiver that translate baseband signal into RF and vice versa. In this paper, 2.4 GHz double balanced Gilbert Cell Mixer topology was simulated to study its important properties such as Conversion Gain, Linearity, Noise Figure and Port Isolation. Further, a band pass filter is added in to the design at IF port so as to reject...
متن کامل