Searching for excess heat in Mizuno-type plasma electrolysis
نویسندگان
چکیده
Excess heat generated in the glow discharge plasma electrolysis, first reported by Mizuno and Ohmori (1), has been studied by several researchers, both in Japan (2, 3, 4) and in other countries (5, 6, 7, 8). Most reports, but not all, confirmed generation of excess heat. Facing this situation we decided to replicate the most recent experiment (8) in which excess heat was reported to increase with voltage. Our results do not confirm reality of excess heat.
منابع مشابه
Cold Fusion By Plasma Electrolysis of Water
It has been disclosed that transmutation of the atomic nuclei of alkaline metals and the atomic nuclei of the cathode material takes place during plasma electrolysis of water. As a result, excessive quantity of gases is generated.
متن کاملCALORIMETRIC MEASUREMENTS DURING Pd-Ni THIN FILM– CATHODES ELECTROLYSIS IN Li2SO4/H2O SOLUTION
A sensitive open-type calorimeter was used to measure excess heat production during electrolysis in Li2SO4/H2O solution with Pt-anode and Pd-Ni thin film cathodes 9000 Å thick, sputtered on Al2O3 substrate. In order to estimate the actual performance and possible measurement errors during electrolysis in the calorimeter used, including heat convection, bubbling and possible H2+O2 recombination,...
متن کاملHEAT MEASUREMENT DURING LIGHT WATER ELECTROLYSIS USING Pd/Ni ROD CATHODES
The heat balance under electrolysis in 1M Li2SO4 light water solutions was measured using Pd rods or Pd coated Ni (Pd/Ni) rods for cathode. We detected large excess heat of more than 10% in 6 of 28 experiments. However, in many other experiments, no excess or only small excess heat was observed. In most cases the excess heat was 5% or less. In order to confirm the excess heat, we have to find t...
متن کاملUltrasonically-excited electrolysis Experiments at Energetics Technologies
Three electrolysis cells with built-in ultrasonic transmitters were developed by Energetics Technologies. The ultrasonic transmitters induce cavitation in the electrolyte in the vicinity of the palladium cathode for in-situ cleaning and activation of the cathode surface, generation of dislocations, assistance in loading and excitation of the Pd-D system. The ultrasonically assisted electrolysis...
متن کاملCharacteristics of Excess Heat in Pd|D2O+D2SO4 Electrolytic Cells Measured by Seebeck Envelope Calorimetry
Pre-electrolysis at the boiling point in open Pd|D2O cells is an effective method to activate a palladium cathode, which can produce excess power in subsequent electrolysis in closed systems for several months. The reproducibility is 23/45. Another characteristic of excess heat is the apparent resistance of electrolytic cell changes irreversibly with temperature.
متن کامل