Investigation on cold-drawn gold bonding wire with serial and reverse-direction drawing

Gold bonding wires have been manufactured through multiple drawing steps with serial and reverse-direction drawing. The texture and microstrucure of the gold bonding wires were characterized with X-ray diffraction and EBSD and compared with the predictions of finite element (FE) imulation. Initial 〈1 0 0〉 fiber decreases during drawing and is replaced by 〈1 1 1〉 fiber. The 〈1 0 0〉 oriented grains are concentrated in the center nd surface regions, whereas the 〈1 1 1〉 oriented grains are located throughout the cross-section of the wire. Regions near the surface often exhibit he complex textures. A simplified forward and backward drawing process was modeled by FE analysis with ABAQUS/StandardTM. The simple wo-step drawing process results in severe variation in shear strain under the surface and displays the opposite behavior in the shear components f the deformation gradient. The texture evolution was predicted using the deformation gradient calculated in the FE simulations together with a odel of polycrystal plasticity. The 〈1 1 1〉 and 〈1 0 0〉 fibers are predicted to develop in the center part of the wire where homogeneous deformation ccurs. The regions near the surface that experience repeated shear strain exhibit complex textures that deviate from the standard 〈1 1 1〉 and 〈1 0 0〉 bers. The {1 1 2}〈1 1 0〉 and {1 1 1}〈1 1 2〉 components are prevalent in the higher shear strain regions. The variations of the anisotropic elastic irectional moduli with position were also calculated. 2006 Elsevier B.V. All rights reserved.