A study on the characteristics of plasma polymer thin film with controlled nitrogen flow rate
نویسندگان
چکیده
Nitrogen-doped thiophene plasma polymer [N-ThioPP] thin films were deposited by radio frequency (13.56 MHz) plasma-enhanced chemical vapor deposition method. Thiophene was used as organic precursor (carbon source) with hydrogen gas as the precursor bubbler gas. Additionally, nitrogen gas [N2] was used as nitrogen dopant. Furthermore, additional argon was used as a carrier gas. The as-grown polymerized thin films were analyzed using ellipsometry, Fourier-transform infrared [FT-IR] spectroscopy, Raman spectroscopy, and water contact angle measurement. The ellipsometry results showed the refractive index change of the N-ThioPP film. The FT-IR spectra showed that the N-ThioPP films were completely fragmented and polymerized from thiophene.
منابع مشابه
Process Optimization of Deposition Conditions for Low Temperature Thin Film Insulators used in Thin Film Transistors Displays
Deposition process for thin insulator used in polysilicon gate dielectric of thin film transistors are optimized. Silane and N2O plasma are used to form SiO2 layers at temperatures below 150 ºC. The deposition conditions as well as system operating parameters such as pressure, temperature, gas flow ratios, total flow rate and plasma power are also studied and their effects are discussed. The p...
متن کاملPhysical Properties of Reactively Sputter-Deposited C-N Thin Films
This work aims to prepare and study amorphous carbon nitride (CNx) films. Films were deposited by reactive magnetron radiofrequency (RF) sputtering from graphite target in argon and nitrogen mixture discharge at room temperature. The ratio of the gas flow rate was varied from 0.1 to 1. Deposited films were found to be amorphous. Highest Nitrogen concentration achieved was 42 atomic percent whic...
متن کاملDry etching characteristics of amorphous As2S3 film in CHF3 plasma
The authors describe the dry etching characteristics of amorphous As2S3 films in CHF3 plasma and the development of an optimized fabrication process for compact waveguides. The observed etching behavior is due to the relative densities of fluorine atoms, polymer precursors, and ions in the plasma which are controlled by the process parameters. In particular, the flow rate of the CHF3 gas has a ...
متن کاملInfluence of O2 and N2 Concentrations on the Characteristics of Plasma in DC Cylindrical Magnetron Discharge by Langmuir Probe
Using the Langmuir probe method, the reactive plasma parameters were studied in different ratios of oxygen and nitrogen concentrations in a DC cylindrical discharge device.The plasma parameters such as plasma potential, electron density and electron temperature wereextracted from the current-voltage characteristic’s curve of Langmuir probe to find the optimum conditions for deposit the oxy...
متن کاملSynthesis and Study of Lidocaine Hydrochloride from Polymeric Film as a Wound Dressing
Introduction: Among various carrier materials capable of drug controlled-release, silica xerogels have been found to be noteworthy for loading and sustaining drug release. These silica xerogels were synthesized through sol-gel technology using Tetraethylortosilicate (TEOS) as a silica precursor. Methods: This study was an experimental basic research, which aimed to characterize the effect of a...
متن کامل