Short Papers Turning of Slender Workpieces: Modeling and Experiments
نویسندگان
چکیده
This paper introduces a dynamic cutting force model for turning of slender workpieces, as well as experimental results related to the frequency response of the workpiece in turning. The model is based on a flexible workpiece and rigid machine tool, and a workpiece displacement dependent cutting force. The model is described and studied theoretically as well as experimentally. The experimental studies utilise both cutting force and workpiece vibration measurements in two orthogonal directions. This data is obtained for both cutting and non-cutting conditions, and analysed in the frequency domain. The model was found to be in partial agreement with the experimental results. The experimental procedure described here represents a new method for determining the cutting process damping ratio, based on differences in the measured workpiece natural frequencies with and without cutting.
منابع مشابه
An effective optimization algorithm for multipass turning of flexible workpieces
Excessive deformations and chatter vibrations are two main obstacles frequently encountered in turning of long slender workpieces. So far, there is seldom reported research using optimization techniques to cope with those difficulties. This paper introduces a new method for optimizing the machining parameters and the sequence of cutting passes in turning of a slender rod to control the deformat...
متن کاملOn the breakup of slender liquid bridges: Experiments and a 1-D numerical analysis
Slender axisymmetric dielectric liquid bridges are made stable by the action of an axial electric field. In this paper, the subsequent dynamics of a slender liquid bridge after turning off the electric field is considered. The evolution in time of the bridge profile is investigated both theoretically and experimentally. A one-dimensional model is used to simulate the dynamic response of the sys...
متن کاملNonlinear Finite Element Modeling of Different Cross-Sectional Shapes of Slender RC Columns Confined with CFRP Wraps
In the present study, non-linear finite element analyses are carried out on the slender reinforced concrete columns wrapped using CFRP composite with different cross-sectional shapes having the same area. Thickness of the CFRP wraps, concrete compressive strength, corner radius, loading condition, slenderness ratio and column size are the main parameters of this study. According to this, four d...
متن کاملNotes on Lactuca saligna in Iran
In the identification process of weed materials available in "IRAN" herbarium, a specimen belonging to the genus Lactuca (Asteraceae) had the following characteristics: Plant annual, many stemmed from base; stem erect-slightly procumbent, slender, glabrous, whitish and leafy. Basal leaves dried; stem leaves ca. 7 × 0.5 cm, glabrous, linear-lanceolate, entire at margin, sessile, auriculate, auri...
متن کاملAn Empirical Study of Diametral Variations in Turning
Predictions of diametral errors in turning often assume that these errors are solely due to bending of the workpiece and tool. However, recent studies indicate that this cannot explain observed diametral errors in short workpieces. This paper presents an empirical study of the effect of cutting parameters and workpiece materia l on diametral errors. Steel and aluminum samples were machined at d...
متن کامل