Comprehensive Numerical Simulation of Filling and Solidification of Steel Ingots
نویسندگان
چکیده
In this paper, a complete three-dimensional numerical model of mold filling and solidification of steel ingots is presented. The risk of powder entrapment and defects formation during filling is analyzed in detail, demonstrating the importance of using a comprehensive geometry, with trumpet and runner, compared to conventional simplified models. By using a case study, it was shown that the simplified model significantly underestimates the defects sources, reducing the utility of simulations in supporting mold and process design. An experimental test was also performed on an instrumented mold and the measurements were compared to the calculation results. The good agreement between calculation and trial allowed validating the simulation.
منابع مشابه
Simulation of Convection and Macrosegregation in a Large Steel Ingot
segregates. Although good agreement with experiments was MACROSEGREGATION in large steel ingots is one achieved, the model relied on many approximations (such of the most well-known and now classical problems in the as estimating the flow velocities). It should also be menfield of solidification and casting.[1] It arises from the relative tioned that many models have appeared in the literature ...
متن کاملThree-dimensional Numerical Simulation of Metal Flow and Solidification in the Multi-cavity Casting Moulds of Automotive Components
The liquid metal flow and the solidification behaviours in a multi-cavity casting mould of two automotive cast parts were simulated in three dimensions. The commercial code, FLOW-3D® was used because it can track the front of the molten metal by a Volume of Fluid (VOF) method and allows complicated parts to be modeled by the Fractional Area/Volume Obstacle Representation (FAVOR) meth...
متن کاملModeling and Simulation of Heat Transfer Phenomenon in Steel Belt Conveyer Sulfur Granulating Process
Complex heat transfer phenomena (including unsteady state conduction, convection and solidification processes) occur in steel belt conveyer sulfur granulating method. Numerical simulation of this technique is performed via a comprehensive and multifaceted one dimensional model. Since the air situated between the adjacent sulfur pastilles is essentially stagnant, therefore, the surface tempe...
متن کاملUsing Finite Point Method for the Numerical Simulation of Heat Transfer Coupled with Microsegregation during Continuous Casting
In the present work, a meshless method called Finite Point Method (FPM) is developed to simulate the solidification process of a continuously cast steel bloom in both primary and secondary cooling regions. The method is based on the use of a weighted least-square interpolation procedure. A transverse slice of the bloom moving at casting speed is considered as the computational domain and two di...
متن کاملMicroscopic Investigations of Axial Zones of Continuous Casting Ingots
K. Janiszewski, Silesian University of Technology, Institute of Technology Metals, Katowice, Poland This paper presents the results of microscopic investigations of the structure and chemical composition of the axial zones of continuous casting ingots of 140 x 140 mm cross-section made of G3Si1 steel, comprising the areas of porosity and axial shrinkage defects. The occurrence of shrinkage holl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 9 شماره
صفحات -
تاریخ انتشار 2016