Design of Power-Rail ESD Clamp Circuit With Ultra-Low Standby Leakage Current in Nanoscale CMOS Technology
نویسندگان
چکیده
An ultra-low-leakage power-rail ESD clamp circuit, composed of the SCR device and new ESD detection circuit, has been proposed with consideration of gate current to reduce the standby leakage current. By controlling the gate current of the devices in the ESD detection circuit under a specified bias condition, the whole power-rail ESD clamp circuit can achieve an ultra-low standby leakage current. The new proposed circuit has been fabricated in a 1 V 65 nm CMOS process for experimental verification. The new proposed power-rail ESD clamp circuit can achieve 7 kV HBM and 325 V MM ESD levels while consuming only a standby leakage current of 96 nA at 1 V bias in room temperature and occupying an active area of only 49 m 21 m.
منابع مشابه
2×VDD-tolerant power-rail ESD clamp circuit with low standby leakage in 65-nm CMOS process
With the consideration of low standby leakage in nanoscale CMOS processes, a new 2×VDD-tolerant ESD clamp circuit was presented in this paper. The new ESD clamp circuit had a high-voltage-tolerant ESD detection circuit to improve the turn-on efficiency of the silicon-controlled-rectifier-based (SCRbased) ESD device. This design had been successfully verified in a 65-nm CMOS process. The leakage...
متن کاملDesign of 2×VDD-Tolerant Power-Rail ESD Clamp Circuit With Consideration of Gate Leakage Current in 65-nm CMOS Technology
A low-leakage 2×VDD-tolerant power-rail electrostatic discharge (ESD) clamp circuit composed of the siliconcontrolled rectifier (SCR) device and new ESD detection circuit, realized with only thin-oxide 1× VDD devices, has been proposed with consideration of gate leakage current. By reducing the voltage across the gate oxides of the devices in the ESD detection circuit, the whole power-rail ESD ...
متن کاملESD Detection Circuit controlling to using ESD Clamp Circuit with adjustable holding voltage and PMOS-Based Power
A new power-rail ESD clamp circuit designed with PMOS as main ESD clamp device has been proposed and verified in a 65nm 1.2V CMOS process. The new proposed design with adjustable holding voltage controlled by the ESD detection circuit has better immunity against mis-trigger or transient-induced latch-on event. The layout area and the standby leakage current of this new proposed design are much ...
متن کاملOverview on ESD protection design for mixed-voltage I/O interfaces with high-voltage-tolerant power-rail ESD clamp circuits in low-voltage thin-oxide CMOS technology
Electrostatic discharge (ESD) protection design for mixed-voltage I/O interfaces has been one of the key challenges of system-on-achip (SOC) implementation in nanoscale CMOS processes. The on-chip ESD protection circuit for mixed-voltage I/O interfaces should meet the gate-oxide reliability constraints and prevent the undesired leakage current paths. This paper presents an overview on the desig...
متن کاملMetal-layer capacitors in the 65 nm CMOS process and the application for low-leakage power-rail ESD clamp circuit
Between the metal–insulator–metal (MIM) capacitor and metal–oxide–metal (MOM) capacitor, the MIM capacitor has a better characteristic of stable capacitance. However, the MOM capacitors can be easily realized through the metal interconnections, which does not need additional fabrication masks into the process. Moreover, the capacitance density of the MOM capacitor can exceed the MIM capacitor w...
متن کامل