Ex-situ depth-sensing indentation measurements of electrochemically produced Si–Li alloy films
نویسندگان
چکیده
منابع مشابه
Phase transformations induced by spherical indentation in ion-implanted amorphous silicon
The deformation behavior of ion-implanted unrelaxed and annealed ion-implanted relaxed amorphous silicon a-Si under spherical indentation at room temperature has been investigated. It has been found that the mode of deformation depends critically on both the preparation of the amorphous film and the scale of the mechanical deformation. Ex situ measurements, such as Raman microspectroscopy and c...
متن کاملDesign and investigation of TiO2 –SiO2 thin films on AISI 316L stainless steel for tribological properties and corrosion protection
The TiO2–SiO2 thin films were deposited on AISI 316L stainless steel via sol-gel method. Then, the effect of the added amount of SiO2 on the structure, morphology and mechanical properties of the films and corrosion behavior of AISI 316L stainless steel substrate were investigated. So, X-ray diffraction, field-emission scanning electron microscopy, atomic force microscopy, depth-sensing indenta...
متن کاملNano-indentation of Copper Thin Films on Silicon Substrates
Indentation methods are finding increasing use in the study of mechanical properties of bulk and thin-film materials over a wide range of size scales (e.g., [1,2]). With the increasing sophistication of instrumented, depth-sensing indentation equipment and of computational methods to model the deformation of materials subjected to indentation, there is growing interest in studying the elastopla...
متن کاملTi-Si-C thin films produced by magnetron sputtering: correlation between physical properties, mechanical properties and tribological behavior.
Ti-Si-C thin films were deposited onto silicon, stainless steel and high-speed steel substrates by magnetron sputtering, using different chamber configurations. The composition of the produced films was obtained by Electron Probe Micro-Analysis (EPMA) and the structure by X-ray diffraction (XRD). The hardness and residual stresses were obtained by depth-sensing indentation and substrate deflect...
متن کاملQuantitative fracture strength and plasticity measurements of lithiated silicon nanowires by in situ TEM tensile experiments.
We report in situ tensile strength measurement of fully lithiated Si (Li-Si alloy) nanowires inside a transmission electron microscope. A specially designed dual probe with an atomic force microscopy cantilever and a scanning tunneling microscopy electrode was used to conduct lithiation of Si nanowires and then perform in situ tension of the lithiated nanowires. The axial tensile strength decre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2013