Theoretical model for local heat transfer coefficient for annular flow boiling in circular mini/micro-channels
نویسندگان
چکیده
Article history: Received 15 October 2013 Received in revised form 19 February 2014 Accepted 20 February 2014 Available online 19 March 2014
منابع مشابه
Flow boiling heat transfer in two-phase micro-channel heat sinks––II. Annular two-phase flow model
This paper is Part II of a two-part study devoted to measurement and prediction of the saturated flow boiling heat transfer coefficient in water-cooled micro-channel heat sinks. Part I discussed the experimental findings from the study, and identified unique aspects of flow boiling in micro-channels such as abrupt transition to the annular flow regime near the point of zero thermodynamic equili...
متن کاملFlow boiling heat transfer in two-phase micro-channel heat sinks––I. Experimental investigation and assessment of correlation methods
This paper is the first of a two-part study concerning measurement and prediction of saturated flow boiling heat transfer in a water-cooled micro-channel heat sink. In this paper, new experimental results are discussed which provide new physical insight into the unique nature of flow boiling in narrow rectangular micro-channels. The micro-channel heat sink contained 21 parallel channels having ...
متن کاملFlow boiling of water in a circular staggered micro-pin fin heat sink
Flow boiling of water across a bank of circular staggered micro-pin fins, 250 lm long and 100 lm diameter with pitch-to-diameter ratio of 1.5, was experimentally studied for mass fluxes ranging from 346 kg/m s to 794 kg/m s and surface heat fluxes ranging from 20 W/cm to 350 W/cm. Local temperature measurements were used to elucidate the two-phase heat transfer coefficients. The flow was visual...
متن کاملFlow condensation in parallel micro-channels – Part 2: Heat transfer results and correlation technique
This second part of a two-part study concerns heat transfer characteristics for FC-72 condensing along parallel, square micro-channels with a hydraulic diameter of 1 mm, which were formed in the top surface of a solid copper plate. Heat from the condensing flow was rejected to a counter flow of water through channels brazed to the underside of the copper plate. The FC-72 condensation heat trans...
متن کاملAn approximate model for slug flow heat transfer in channels of arbitrary cross section
In this paper, a novel approximate solution to determine the Nusselt number for thermally developed, slug (low-prandtl), laminar, single phase flow in channels of arbitrary cross section is presented. Using the Saint-Venant principle in torsion of beams, it is shown that the thermally developed Nusselt number for low-prandtl flow is only a function of the geometrical parameters of the channel c...
متن کامل