On machining of hardened AISI D2 steel with PCBN tools
نویسندگان
چکیده
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life and volume of material removal were obtained at the lowest speed tested (70 m/min), indicating that this speed is more suitable for machining the selected tool/work material combination. While the highest feed used resulted in the highest volume of material removal, lower feeds resulted in higher
منابع مشابه
Experimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel
Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...
متن کاملHard turning with variable micro-geometry PcBN tools
This paper presents investigations on hard turning with variable edge design PcBN inserts. Turning of hardened AISI 4340 steel with uniform and variable edge design PcBN inserts is conducted, forces and tool wear are measured. 3D finite element modelling is utilized to predict chip formation, forces, temperatures and tool wear on uniform and variable edge micro-geometry tools. Predicted forces ...
متن کاملExperimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel
Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...
متن کامل3-d Fea of Hard Turning: Investigation of Pcbn Cutting Tool Micro- Geometry Effects
In this study, 3-D finite element modeling of precision hard turning has been used to investigate the effects of cutting edge microgeometry on tool forces, temperatures and stresses in machining of AISI H13 steel using polycrystalline cubic boron nitrite (PCBN) inserts with two distinct edge preparations. Hard turning experiments were conducted to investigate the effects of cutting edge geometr...
متن کاملPrediction of Tool Life in End Milling of Hardened Steel AISI D2
Most published research works on the development of tool life model in machining of hardened steels have been mainly concerned with the turning process, whilst the milling process has received little attention due to the complexity of the process. Thus, the aim of present study is to develope a tool life model in end milling of hardened steel AISI D2 using PVD TiAlN coated carbide cutting tool....
متن کامل