Separation of Copper from Chalcopyrite – Ammoniacal Leach Liquor Containing Copper, Zinc, and Magnesium by Supported Liquid Membrane
نویسندگان
چکیده
A low grade chalcopyrite ore was leached with H2O2/(NH4)2SO4 and the leach liquor contained 42.96 mol m copper, 3.52 mol m zinc and 11.23 mol m magnesium. From this leach liquor separation of copper was carried out with supported liquid membrane using LIX84I as mobile carrier. Celgard 2400, a microporous polypropylene film was used as the solid support for the liquid membrane. The effect of pH of the feed solution and carrier concentration in membrane phase on copper flux was investigated. It was observed that copper flux increased from 0.92 to 6.3110 mol m s with increase in pH of the feed solution from 1.5 to 3.0 but the flux decreased to 5.9510 mol m s with increasing the feed solution pH to 3.5. Also, the copper flux increased with the increase of LIX 84I concentration (0.361 – 1.44 mol L) in the membrane phase from 1.02 to 6.6010 mol m s and thereafter decreased to 5.2310 mol m s at 1.805 mol L LIX84I. From the slope analysis data, the number of hydrogen ions released and the number of extractant molecules associated with the extracted complex was determined. The forward reaction rate constant, k1 and aqueous film diffusion constant, kw were calculated to be 3.34 10/9.1310 m s and 2.4010 m s, respectively. The separation factors PCu/PZn and PCu/PMg were calculated and reported in the paper.
منابع مشابه
Comparison of various extractants for recovery of Copper from Sarcheshmeh Chalcopyrite concentrate Ammonia/Ammonium Carbonate Leaching
Solvent extraction of copper from the copper leach solution obtained from the ammoniacal carbonate leaching of the Sarcheshmeh copper concentrate was carried out, and the performance of CP-150, LIX984N, and Kelex100 as well as the effects of different parameters involved were investigated. According to the results obtained, the extraction kinetics of all the three extractants was fast. High con...
متن کاملExtraction-Stripping Patterns during Co-Extraction of Copper and Nickel from Ammoniacal Solutions into Emulsion Liquid Membranes Using LIX 84I®
Extraction of nickel and its co-extraction with copper from ammoniacal media into emulsion liquid membrane systems (ELMs) was investigated using LIX 84I as the carrier. Measurement of the solute stripped in the internal phase of emulsion opened a new dimension in the study of the ELM extraction processes. The effect of operating parameters such as feed pH, initial feed concentration, and treat ...
متن کاملFluoride Precipitation of Cu Over Fe in a Selected pH Window
Fe is an impurity in most leach liquors. Its coexistence with copper in leaching solution of chalcopyrite (CuFeS2) which is the most important mineral of copper creates major extraction problems. Hydrochloric acid dissolves both copper and iron during chloride leaching of this mineral. Separation of Fe from Cu is thus necessary to obtain pure copper. This paper presents a novel metho...
متن کاملAlternative solution purification in the
More than 80% of the world’s production of zinc from its concentrate is obtained by the roastleach-electrowin hydrometallurgical process. In the roast-leach process, very pure zinc sulphate solution must be prepared for zinc electrowinning, therefore, the purification process is one of the most important unit processes in zinc hydrometallurgy. The conventional methods for the zinc solution puri...
متن کاملSeparation of Manganese and Iron from Reductive Leaching Liquor of Electric Arc Furnace Dust of Ferromanganese Production Units by Solvent Extraction
Electric arc furnace dust (EAFD) of ferromanganese production units, in the form of slurry, contains tar, alkalies, manganese, zinc, iron, silica, calcium, aluminum and other elements. A hydrometallurgical route based on solvent extraction technique was investigated for selective separation of manganese from the dust. Leaching of the EAFD resulted in an aqueous feed containing 4 g/L of manganes...
متن کامل