A Three-Dimensional Microdisplacement Sensing System Based on MEMS Bulk-Silicon Technology
نویسندگان
چکیده
For the dimensional measurement and characterization of microsized and nanosized components, a three-dimensional microdisplacement sensing system was developed using the piezoresistive effect in silicon. The sensor was fabricated using microelectromechanical system bulk-silicon technology, and it was validated using the finite element method. A precise data acquisition circuit with an accuracy of 20 μV was designed to obtain weak voltage signals. By calibration, the sensing system was shown to have a sensitivity of 17.29 mV/μm and 4.59 mV/μm in the axial and lateral directions, respectively; the nonlinearity in these directions was 0.8% and 1.0% full scale, respectively. A full range of 4.6 μm was achieved in the axial direction. Results of a resolution test indicated that the sensing system had a resolution of 5 nm in the axial direction and 10 nm in the lateral direction.
منابع مشابه
Three-Dimensional Simulation of Anisotropic Wet Chemical Etching Process
In this paper, we present result on the development of a simulation tool for the three-dimensional anisotropic wet chemical etching of bulk silicon etching or bulk micromaching. As a test of our simulation tool, we present several simulation results. Several simulation results demonstrate our simulation tool which is quite efficient for the design and development of MEMS device structure. The d...
متن کاملOxidised Macro Porous Silicon based Thermal Isolation in the Design of Microheater for MEMS based Gas Sensors
Chemical gas sensors suffers from the drawbacks such as high temperature ((>=300oC) and very high power consumption for sensing inflammable gases like CO, CH4 etc. In this work a new technique for thermal isolation in MEMS gas sensors is presented by coupling micromachining of bulk silicon and oxidized macro porous silicon (OMPS) layer to reduce the
متن کاملA Low-Cost CMOS-MEMS Piezoresistive Accelerometer with Large Proof Mass
This paper reports a low-cost, high-sensitivity CMOS-MEMS piezoresistive accelerometer with large proof mass. In the device fabricated using ON Semiconductor 0.5 μm CMOS technology, an inherent CMOS polysilicon thin film is utilized as the piezoresistive sensing material. A full Wheatstone bridge was constructed through easy wiring allowed by the three metal layers in the 0.5 μm CMOS technology...
متن کاملAnalytical Approach for Vibration Analysis of a Microsensor with Two layers of Silicon and Piezoelectric based on MCST
The vibration analysis is an important step in the design and optimization of microsensors. In most of the cases, COMSOL software is employed to consider the size-dependency on the dynamic behavior in the MEMS sensors. In this paper, the Modified Couple Stress Theory (MCST) is used to capture the size effect on dynamic behavior in a microsensor with two layers of the silicon and piezoelectric. ...
متن کاملSilicon-based MEMS fabrication techniques and standardization
The silicon-based MEMS fabrication technology, including bulk micromachining and sacrificial layers technology have been developed and studied. The 3-D fabrication and integration of silicon-based MEMS and standard process fabrication have been studied in the present paper. 1 Introduction MEMS devices and systems offer advantages of small volume, light weight, low power, and the integration of ...
متن کامل