Surface Roughness Effects in Pure Sliding EHL Line Contacts with Carreau-Type Shear-Thinning Lubricants

نویسندگان

  • Lubricants Punit Kumar
  • Niraj Kumar
چکیده

The influence of transverse surface roughness on EHL characteristics has been investigated numerically using an extensive set of full EHL line contact simulations for shear-thinning lubricants under pure sliding condition. The shear-thinning behavior of lubricant is modeled using Carreau viscosity equation along with Doolittle-Tait equation for lubricant compressibility. The surface roughness is assumed to be sinusoidal and it is present on the stationary surface. It is found that surface roughness causes sharp pressure peaks along with reduction in central and minimum film thickness. With increasing amplitude of surface roughness, the minimum film thickness decreases much more rapidly as compared to the central film thickness. Keywords—EHL, Carreau, Shear-thinning, Surface Roughness, Amplitude, Wavelength.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Traction Behavior of Linear Piezo-Viscous Lubricants in Rough Elastohydrodynamic Lubrication Contacts

Abstract—The traction behavior of lubricants with the linear pressure-viscosity response in EHL line contacts is investigated numerically for smooth as well as rough surfaces. The analysis involves the simultaneous solution of Reynolds, elasticity and energy equations along with the computation of lubricant properties and surface temperatures. The temperature modified Doolittle-Tait equations a...

متن کامل

Hydrodynamic and Elastohydrodynamic Lubrication

Contents 1. Introduction 2. Stress-induced lubricant degradation 3. Basic equations governing the fluid elastohydrodynamic lubrication (EHL) of line and point contacts 3.1. Equations of fluid motion 3.2. Contact surface displacements in line and point lubricated contacts 4. Steady isothermal EHL problems for lightly loaded non-conformal line contacts 5. Steady isothermal EHL problems for heavil...

متن کامل

Analysis of Mixed Lubrication Effects in Simulated Gear Tooth Contacts

The paper presents results obtained using a transient analysis technique for point contact elastohydrodynamic lubrication (EHL) problems based on a formulation that couples the elastic and hydrodynamic equations. Results are presented for transverse ground surfaces in elliptical point contact that show severe film thinning and asperity contact at the transverse limits of the contact area. This ...

متن کامل

A unified shear-thinning treatment of both film thickness and traction in EHD

A conclusive demonstration has been provided that the nature of the shearthinning, that affects both film thickness and traction in EHL contacts, follows the ordinary power-law rule that has been described by many empirical models of which Carreau is but one example. This was accomplished by accurate measurements in viscometers of the shear response of a PAO that possesses a very low critical s...

متن کامل

Comparison of fatigue model results for rough surface elastohydrodynamic lubrication

The paper compares the results of applying different fatigue failure models to surfaces that experience elastohydrodynamic lubrication (EHL) and have surface roughness features which are large compared with the equivalent smooth surface film thickness. The surface profiles used for the comparisons reported are taken from test gear surfaces used in an FZG gear test. The surface has a roughness o...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2014