Sine Wave Test of Adc's: Means for International Comparison
نویسندگان
چکیده
ADC data sheets and test methods are not yet standardized. A new attempt to create a common platform for these is the draft standard IEEE-STD-1241. However, the methods described in this standard need an extra effort from the user to exactly understand and implement them. It is therefore very reasonable to provide programs which implement these methods, and allow manufacturers and users to use them. This assures that the same characterizing quantities will be used for the same purpose by everyone. The first attempt for this was a LabView program announced in 1999. In this paper another implementation is presented, running under MATLAB. This will hopefully extend the number of the users of the methods described in the standard.
منابع مشابه
Oscillation Control of Aircraft Shock Absorber Subsystem Using Intelligent Active Performance and Optimized Classical Techniques Under Sine Wave Runway Excitation (TECHNICAL NOTE)
This paper describes third aircraft model with 2 degrees of freedom. The aim of this study is to develop a mathematical model for investigation of adoptable landing gear vibration behavior and to design Proportional Integration Derivative (PID) classical techniques for control of active hydraulic nonlinear actuator. The parameters of controller and suspension system are adjusted according to be...
متن کاملCorrected rms error and effective number of bits for sine wave ADC tests
A new definition is proposed for the effective number of bits of an ADC. This definition removes the variation in the calculated effective bits when the amplitude and offset of the sinewave test signal is slightly varied. This variation is most pronounced when test signals with amplitudes of a small number of code bin widths are applied to very low noise ADC's. The effectiveness of the proposed...
متن کاملEvaluation of Sine Wave Tests of Adc's from Windowed Data
Recently, much excitement has been caused in the EUPAS group by the evaluation of the IEEE 1241 draft standard. This draft contains a lot of useful information and several well established facts. However, there are also some details which are not fully clarified, or need further examination. This paper deals with one of these: the possibility of data processing, based on windowed data.
متن کاملStandard Environment for the Sine Wave Test of Adc's
ADC data sheets and test methods are not yet standardized. A new attempt to create a common platform for these is the draft standard IEEE-STD-1241. However, the methods described in this standard need an extra effort from the user to exactly understand and implement them. It is therefore very reasonable to provide programs which implement these methods, and allow manufacturers and users to use ...
متن کاملA Non-Sinusoidal Reference Wave for Pwm Ac Drives
In this paper we propose a suitable reference wave for Pulse Width Modulation (PWM) AC Drives. Staircase reference waves whose levels are calculated to eliminate certain harmonics are studied and a certain staircase reference waveform with L levels is constructed. When L is made very large in limit, this staircase waveform approaches a continuous one which is called Quasine (Quasi + Sine). This...
متن کامل