An Improved System for Utilizing Low-Temperature Waste Heat of Flue Gas from Coal-Fired Power Plants
نویسندگان
چکیده
In this paper, an improved system to efficiently utilize the low-temperature waste heat from the flue gas of coal-fired power plants is proposed based on heat cascade theory. The essence of the proposed system is that the waste heat of exhausted flue gas is not only used to preheat air for assisting coal combustion as usual but also to heat up feedwater and for low-pressure steam extraction. Air preheating is performed by both the exhaust flue gas in the boiler island and the low-pressure steam extraction in the turbine island; thereby part of the flue gas heat originally exchanged in the air preheater can be saved and introduced to heat the feedwater and the high-temperature condensed water. Consequently, part of the high-pressure steam is saved for further expansion in the steam turbine, which results in additional net power output. Based on the design data of a typical 1000 MW ultra-supercritical coal-fired power plant in China, an in-depth analysis of the energy-saving characteristics of the improved waste heat utilization system (WHUS) and the conventional WHUS is conducted. When the improved WHUS is adopted in a typical 1000 MW unit, net power output increases by 19.51 MW, exergy efficiency improves to 45.46%, and net annual revenue reaches USD 4.741 million while for the conventional WHUS, these performance parameters are 5.83 MW, 44.80% and USD 1.244 million, respectively. The research described in this paper provides a feasible energy-saving option for coal-fired power plants.
منابع مشابه
Improvement of Efficiency of Coal-Fired Steam Power Plant by Reducing Heat Rejection Temperature at Condenser Using Kalina Cycle
This paper proposes an approach for improving the plant efficiency by reducing the heat rejection temperature of power cycle using Kalina Cycle System 11 (KCS11) which is integrated at the steam condenser of a 500 MWe SubC (subcritical) coal-fired power plant. It is modelled by using power plant simulation software ‘Cycle Tempo’ at different plant operating conditions. Results show t...
متن کاملNovel catalytic process for flue gas conditioning in electrostatic precipitators of coal-fired power plants.
One of the most important environmental protection problems for coal-fired power plants is prevention of atmospheric pollution of flying ash. The ash particles are typically removed from flue gases by means of electrostatic precipitators, for which the efficiency may be significantly increased by lowering the resistance of fly ash, which may be achieved by controlled addition of microamounts of...
متن کاملAn Improved Flexible Solar Thermal Energy Integration Process for Enhancing the Coal-Based Energy Efficiency and NOx Removal Effectiveness in Coal-Fired Power Plants under Different Load Conditions
An improved flexible solar-aided power generation system (SAPG) for enhancing both selective catalytic reduction (SCR) de-NOx efficiency and coal-based energy efficiency of coal-fired power plants is proposed. In the proposed concept, the solar energy injection point is changed for different power plant loads, bringing about different benefits for coal-fired power generation. For partial/low lo...
متن کاملThis Drying System Uses a Combination of Thermal Energy from Boiler and Condenser Cooling Water as the Heat Source for Coal Drying USE OF POWER PLANT WASTE HEAT TO REDUCE COAL MOISTURE PROVIDES PLANT PERFORMANCE AND ENVIRONMENTAL BENEFITS
In recent years, subbituminous coal from the Powder River Basin and lignites from Texas and North Dakota have captured an increasing share of the power generation market involving pulverized coal-fired power plants. However, these coals contain relatively large amounts of moisture, which affect unit performance, stack emissions and plant maintenance costs. The moisture also results in fuel hand...
متن کاملModeling of Gas-Particle-Flow and Heat Radiation in Steam Power Plants
Fired steam generators are the dominating technology of coal combustion in power plants. This paper presents a model for pulverized coal fired steam generators in Modelica. The model components are designed as an extension of SiemensPower, a Modelica library for transient simulation of power plants. The focus is on coal combustion, gas-particle-flow and radiation heat transfer in the furnace. T...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Entropy
دوره 19 شماره
صفحات -
تاریخ انتشار 2017