Constitutive Property Testing and Reliability Assessment of Lead - Free Solder Joint
نویسنده
چکیده
Title of Document: CONSTITUTIVE PROPERTY TESTING AND RELIABILITY ASSESSMENT OF LEADFREE SOLDER JOINT Yuri Lee, Master, 2010 Directed By: Professor Bongtae Han, Department of Mechanical Engineering A modified single lap shear test configuration, based on the Iosipescu geometry, is proposed to characterize mechanical properties of solder alloys. In the method, an auxiliary device (extension unit) is employed to improve the accuracy of measurement. The extension unit is attached directly to the test area. The unit converts shear displacements to axial displacements, which are subsequently captured by a high-resolution extensometer. The extension unit allowed measurement of shear deformations without compensating machine and grip compliance. The proposed test configuration is utilized to characterize the constitutive properties of lead-free solder. Experimental parameters are obtained for (1) a partitioned model, where the elastic, rate-independent plastic and rate-dependent creep behaviors are all separated and (2) a unified creep-plastic model. Reliability assessment of lead-free solder joint is performed by calibration of virtual qualification model for leaded packages with lead-free solder. CONSTITUTIVE PROPERTY TESTING AND RELIABILITY ASSESSMENT OF LEAD-FREE SOLDER JOINT
منابع مشابه
Solder Joint Reliability Assessment for a High Performance RF Ceramic Package
The prediction of long term solder joint reliability, (SJR), of microelectronic devices and packaging solutions continues to challenge the microelectronic packaging industry, particularly with the introduction of lead-free materials, the push for higher performance (frequency/speed/thermal) and lower unit cost. High performance packages are generally custom designed and therefore have minimal i...
متن کاملLead-free Solder Joint Reliability – State of the Art and Perspectives
There is an increasing demand for replacing tin-lead (Sn/Pb) solders with lead-free solders in the electronics industry due to health and environmental concerns. The European Union recently passed a law to ban the use of lead in electronic products. The ban will go into effect in July of 2006. The Japanese electronics industry has worked to eliminate lead from consumer electronic products for s...
متن کاملRELIABILITY ASSESSMENT OF REBALLED BGAs
The Printed Circuit Board (PCB) assembly domain has almost completed its transition to a lead-free environment. This shift has resulted in the obsolescence of tin-lead components. However, occasionally, on-going production or repair processes require SnPb components which are no longer available. Using a lead-free device in such cases could result in reliability concerns (due to the use of lead...
متن کاملSolder joint reliability under realistic service conditions
The ultimate life of a microelectronics component is often limited by failure of a solder joint due to crack growth through the laminate under a contact pad (cratering), through the intermetallic bond to the pad, or through the solder itself. Whatever the failure mode proper assessments or even relative comparisons of life in service are not possible based on accelerated testing with fixed ampl...
متن کاملThermal Cycling Life Prediction of Sn-3.0Ag-0.5Cu Solder Joint Using Type-I Censored Data
Because solder joint interconnections are the weaknesses of microelectronic packaging, their reliability has great influence on the reliability of the entire packaging structure. Based on an accelerated life test the reliability assessment and life prediction of lead-free solder joints using Weibull distribution are investigated. The type-I interval censored lifetime data were collected from a ...
متن کامل