Searching Efficient Protection Strategies for the Eutrophied Gulf of Finland: The Combined Use of One-Dimensional and Three- Dimensional Modeling in Assessing Long-Term State Scenarios with High Spatial Resolution
نویسندگان
چکیده
An ?1 experiment combining the use of two ecosystem models was conducted to search for effective protection strategies for the Gulf of Finland (Baltic Sea). Reference and scenario simulations were first run with a onedimensional (1D) model for seven main basins of the entire Baltic Sea until steady state was achieved. The obtained basinwise distributions of inorganic nitrogen (N) and phosphorus (P), as well as sediment labile P, were then used to initiate 5-y simulations with a threedimensional (3D) ecosystem model. The results suggest that relatively small local load reductions (the ‘‘Finland’’ scenario) would improve only the state of adjacent coastal waters significantly. This would be the case, even for runs covering several decades, which clearly exceed the residence times of nutrients in the Gulf of Finland. A significant decrease from a substantial loading source to the Gulf (the ‘‘St. Petersburg’’ scenario) would decrease cyanobacterial biomasses in the entire Gulf of Finland and also immediately outside it. A reduction in the current Polish nutrient loads would improve the situation in the whole Baltic Proper and cause an extensive decline in cyanobacterial biomasses in the Gulf of Finland, as well. However, it would take several decades until the improvement caused by reducing loads in the ‘‘Poland’’ scenario is seen, while in the St. Petersburg scenario the corresponding time lag would only be a few years. Our results suggest that the common water protection policy in the Baltic Sea region should have the largest nutrient sources as its primary target, regardless of their location and country.
منابع مشابه
Noninvasive Stem Cell Labeling Using USPIO Technique and their Detection with MRI
Background: To date, several imaging techniques to track stem cells are used such as positron emission tomography (PET), single photon emission computed tomography (SPECT), Bioluminescence imaging (BLI), fluorescence imaging, CT scan and magnetic resonance imaging (MRI). Although, overall sensitivity of MRI compared to SPECT and Bioluminescence techniques are lower, but due to high spatial reso...
متن کاملSimulation of Smoke Emission from Fires in High-Rise Buildings Using the 3D Model Generated from 2-Dimensional Cadastral Data
Having a 3-Dimensional model of high-rise buildings can be used in disaster management such as fire cases to reduce casualties. The fundamental dilemma in 3D building modeling is the unavailability of suitable data sources. However, available cadastral 2D maps could be used as low-cost and attainable resources for 3D building modeling. Smoke will be a great threat to people's health during a f...
متن کاملThree-dimensional Magnetotelluric Modeling of data from Northeast of Gorgan Plain
Magnetotelluric measurements have been conducted in the period range of 0.005-128 s along five parallel east-west directed profiles including 85 sites totally in the north-eastern part of Gorgan Plain, Golestan Province, North of Iran; with the aim of exploring iodine. Distortion and dimensionality analysis of data imply the existence of a north-south elongated two-dimensional model with some l...
متن کاملA Three-dimensional Numerical Modeling of Contaminant Dispersion from Arvand Rood River into the Persian Gulf
The Persian Gulf is an important economic and geo-political region. Owing to its oil and gas resources, it is one of the busiest waterways in the world. There are many operating oil wells in the northern part of the Persian Gulf . As a result, the risk of contaminant dispersion is high. The deliberate discharge of 6.3 million barrels of crude oil during the 1991 war against Kuwait in this regio...
متن کاملTwo-Dimetional Hydraulic Simulation of Floods using the LISFLOOD-FP Raster Model (A Case Study: The Shemshak Watershed, Tehran Province)
LISFLOOD-FP belongs to a new generation of hydrodynamic models of flood simulation, which is implemented by a digital elevation map for the river and the waterways, route information and flow rates The LISFLOOD-FP features are two-dimensional hydraulic models: 1. based on raster 2. large scale 3. ease of formulation and high computational efficiency 4. simplicity of use 5. spatial adjustmen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2007