NC OR RE CT ED P RO OF Beam tests of ATLAS SCT silicon strip detector modules

نویسندگان

  • V. Cindro
  • G. Kramberger
چکیده

NC OR RE CT ED P RO OF Beam tests of ATLAS SCT silicon strip detector modules F. Campabadal, C. Fleta, M. Key, M. Lozano, C. Martinez, G. Pellegrini, J.M. Rafi, M. Ullan, L. Johansen, B. Pommeresche, B. Stugu, A. Ciocio, V. Fadeyev, M. Gilchriese, C. Haber, J. Siegrist, H. Spieler, C. Vu, P.J. Bell, D.G. Charlton, J.D. Dowell, B.J. Gallop, R.J. Homer, P. Jovanovic, G. Mahout, T.J. McMahon, J.A. Wilson, A.J. Barr, J.R. Carter, B.P. Fromant, M.J. Goodrick, J.C. Hill, C.G. Lester, M.J. Palmer, M.A. Parker, D. Robinson, A. Sabetfakhri, R.J. Shaw, F. Anghinolfi, E. Chesi, S. Chouridou, R. Fortin, J. Grosse-Knetter, M. Gruwe, P. Ferrari, P. Jarron, J. Kaplon, A. Macpherson, T. Niinikoski, H. Pernegger, S. Roe, A. Rudge, G. Ruggiero, R. Wallny, P. Weilhammer, W. Bialas, W. Dabrowski, P. Grybos, S. Koperny, J. Blocki, P. Bruckman, S. Gadomski, J. Godlewski, E. Gornicki, P. Malecki, A. Moszczynski, E. Stanecka, M. Stodulski, R. Szczygiel, M. Turala, M. Wolter, A. Ahmad, J. Benes, C. Carpentieri, L. Feld, C. Ketterer, J. Ludwig, J. Meinhardt, K. Runge, B. Mikulec, M. Mangin-Brinet, M. D’Onofrio, M. Donega, S. Moêd, A. Sfyrla, D. Ferrere, A.G. lark, E. Perrin, M. Weber, R.L. Bates, A. Cheplakov, D.H. Saxon, V. O’Shea, K.M. Smith, Y. Iwata, T. Ohsugi, T. Kohriki, T. Kondo, S. Terada, N. Ujiie, Y. Ikegami, Y. Unno, R. Takashima, T. Brodbeck, A. Chilingarov, G. Hughes, P. Ratoff, T. Sloan, P.P. Allport, G.-L. Casse, A. Greenall, J.N. Jackson, T.J. Jones, B.T. King, S.J. Maxfield, N.A. Smith, P. Sutcliffe, J. Vossebeld, G.A. Beck, A.A. Carter, S.L. Lloyd, A.J. Martin, J. Morris, J. Morin, K. Nagai, T.W. Pritchard, B.E. Anderson, J.M. Butterworth, T.J. Fraser, T.W. Jones, J.B. Lane, M. Postranecky, M.R.M. Warren, V. Cindro, G. Kramberger, I. Mandić, M. Mikuž, I.P. Duerdoth, J. Freestone, J.M. Foster, M. Ibbotson, F.K. Loebinger, J. Pater, S.W. Snow, R.J. Thompson, T.M. Atkinson, U

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Diagnostic Analysis of Silicon Strips Detector Readout in the ATLAS Semi-Conductor Tracker Module Production

The ATLAS Semi-Conductor Tracker (SCT) Collaboration is currently in the production phase of fabricating and testing silicon strips modules for the ATLAS detector at the Large Hadron Collider being built at the CERN laboratory in Geneva, Switzerland. A small but relevant percentage of ICs developed a new set of defects after being mounted on hybrids that were not detected in the wafer screening...

متن کامل

Alignment of the Pixel and SCT Modules for the 2004 ATLAS Combined Test Beam

A small set of final prototypes of the ATLAS Inner Detector silicon tracker (Pixel and SCT) were used to take data during the 2004 Combined Test Beam. Data were collected from runs with beams of different flavour (electrons, pions, muons and photons) with a momentum range of 2 to 180 GeV/c. Four independent methods were used to align the silicon modules. The corrections obtained were validated ...

متن کامل

Detector modules for the ATLAS SCT endcaps

1976 double-sided detector modules are needed to equip the endcaps of the silicon microstrip tracker SCT of the ATLAS experiment at the LHC. This paper describes their design and presents results from a series of prototype

متن کامل

Test of ATLAS SCT barrel modules with Nd:YAG laser

As a part of the quality assurance procedure of the ATLAS SCT (Semiconductor Tracker) barrel modules, the response of the microstrip detector is measured by injecting focused Nd:YAG laser at each strip. The test is sensitive to sensor originated problems and a cross check to the results obtained from the electrical tests performed with the test pulse system implemented in the readout ASICs. Com...

متن کامل

Robotic mounting of ATLAS barrel SCT modules

The 2112 silicon detector modules of the barrel part of the ATLAS SemiConductor Tracker (SCT) have been mounted on their carbon fibre support structure. Module insertion, placement and fixing were performed by robotic assembly tooling. We report on our experience with this assembly method. Part of the mounting sequence involves a partial survey of elements of the support structure which is need...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004