Al-Zn-Sn-O Thin Film Transistors with Top and Bottom Gate Structure for AMOLED
نویسندگان
چکیده
We have fabricated the transparent bottom gate and top gate TFTs using new oxide material of Al-Zn-Sn-O (AZTO) as an active layer. The AZTO active layer was deposited by RF magnetron sputtering at room temperature. Our novel TFT showed good TFT performance without post-annealing. The field effect mobility and the sub-threshold swing were improved by the post-annealing, and the mobility increased with SnO2 content. The AZTO TFT (about 4 mol% AlOx, 66 mol% ZnO, and 30 mol% SnO2) exhibited a mobility of 10.3 cm2/Vs, a turn-on voltage of 0.4 V, a sub-threshold swing of 0.6 V/dec, and an on/off ratio of 109. Though the bottom gate AZTO TFT showed good electrical performance, the bias stability was relatively poor. The bias stability was significantly improved in the top gate AZTO TFT. We have successfully fabricated the transparent AMOLED panel using the back-plane composed with top gate AZTO TFT array. key words: thin film transistor, oxide, AMOLED, transparent
منابع مشابه
3.5-Inch QCIF AMOLED Panels with Ultra-low-Temperature Polycrystalline Silicon Thin Film Transistor on Plastic Substrate
ETRI Journal, Volume 30, Number 2, April 2008 In this paper, we describe the fabrication of 3.5-inch QCIF active matrix organic light emitting display (AMOLED) panels driven by thin film transistors, which are produced by an ultra-low-temperature polycrystalline silicon process on plastic substrates. The over all processing scheme and technical details are discussed from the viewpoint of mechan...
متن کاملCarbon nanotube thin film transistors based on aerosol methods.
We demonstrate a fabrication method for high-performance field-effect transistors (FETs) based on dry-processed random single-walled carbon nanotube networks (CNTNs) deposited at room temperature. This method is an advantageous alternative to solution-processed and direct CVD grown CNTN FETs, which allows using various substrate materials, including heat-intolerant plastic substrates, and enabl...
متن کاملOrganic Thin Film Transistors with Polyvinylpyrrolidone / Nickel Oxide Sol-Gel Derived Nanocomposite Insulator
Polyvinylpyrrolidone / Nickel oxide (PVP/NiO) dielectrics were fabricated with sol-gel method using 0.2 g of PVP at different working temperatures of 80, 150 and 200 ºC. Structural properties and surface morphology of the hybrid films were investigated by X- Ray diffraction (XRD) and Scanning Electron Microscope (SEM) respectively. Energy dispersive X-ray spec...
متن کاملProcess Optimization of Deposition Conditions for Low Temperature Thin Film Insulators used in Thin Film Transistors Displays
Deposition process for thin insulator used in polysilicon gate dielectric of thin film transistors are optimized. Silane and N2O plasma are used to form SiO2 layers at temperatures below 150 ºC. The deposition conditions as well as system operating parameters such as pressure, temperature, gas flow ratios, total flow rate and plasma power are also studied and their effects are discussed. The p...
متن کاملTop Gate Amorphous In−Ga−Zn−O Thin Film Transistors Fabricated on Soda−Lime−Silica Glass Substrates
This work presents a comparative analysis of top gate a-IGZO TFTs fabricated on both soda-lime-silica glass and alkali-free borosilicate glass. Low-temperature ALD is selected for the deposition of gate dielectric to minimize a thermal stress. Comparing with TFTs on alkali-free borosilicate glass, TFTs with soda-lime-glass show similar threshold voltage and subthreshold swing, but slightly degr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- IEICE Transactions
دوره 92-C شماره
صفحات -
تاریخ انتشار 2009