“Pore-Like” Effects of Super-Molecular Self-Assembly on Molecular Diffusion of Poly(Ethylene Oxide)-Poly(Propylene Oxide)-Poly(Ethylene Oxide) in Water
نویسندگان
چکیده
Molecular diffusion of triblock copolymers poly(ethylene oxide)-poly(propylene oxide)-poly(ethylene oxide) in water was studied with the help of Pulsed Field Gradient NMR in the broad range of polymer weight fractions from 0.09 to 0.8. Owing to amphiphilic nature of the molecules, these block copolymers exhibit rich self-organization properties when mixed with water. In particular, at ambient temperatures they form micelles and three liquid crystalline mesophases: cubic, hexagonal, and lamellar. The corresponding super-molecular structure formations were studied with the same block copolymer and at the same temperature. Self-assembly of molecules was shown to produce "pore-like" effects on their self-diffusion properties by imposing severe constraints on the dimensionality of propagation. Diffusion in the hexagonal phase was shown to be quasi one-dimensional in the direction parallel to the long axis of the ordered molecular rods. In the lamellar phase, diffusion was found to be quasi two-dimensional, in the plane of the lamellar structures. The observed diffusion anisotropy was attributed to the effects of the specific molecular ordering on the mesoscopic length scale.
منابع مشابه
Compositional Analysis of the High Molecular Weight Ethylene Oxide Propylene Oxide Copolymer by MALDI Mass Spectrometry
The composition of narrow distribution poly ethylene oxide-propylene oxide copolymer (Mw ~ 8700 Da) was studied using matrix assisted laser desorption ionization (MALDI) mass spectrometry. The ethylene oxide-propylene oxide copolymer produced oligomers separated by 14 Da. The average resolving power over the entire spectrum was 28,000. Approximately 448 isotopically resolved peaks representing ...
متن کاملPlatelet deposition studies on copolyether urethanes modified with poly(ethylene oxide).
Pellethane 2363 80A films and tubings were chemically modified and the effect of these modifications on platelet deposition was studied. Grafting of high molecular weight poly(ethylene oxide) and graft polymerization of methoxy poly(ethylene glycol) 400 methacrylate resulted in surfaces with a good water wettability. The increased hydrophilicity of these modified surfaces could be demonstrated ...
متن کاملEffect of Ethylene Oxide Functional Groups in PEBA-CNT Membranes on CO2/CH4 Mixed Gas Separation
Poly (ether-block-amide) /poly (ethylene glycol)/ carbon nanotubes mixed matrix membranes have been successfully fabricated using solvent evaporation method to determine the effect of ethylene oxide groups on the performance of produced membranes. The effects of CNTs (2-8 wt%) and PEG (up to 50 wt%)were investigated in both single and mixed gas test setup in different temperature and pressure. ...
متن کاملSynthesis and characterization of mesoporous zirconium oxide thin films
Zirconium oxide (ZrO2) has generated wide interest because of its potential in applications such as solid oxide fuel cells, catalysts and optical devices. In these applications, it is important to control the grain size of the material and increase the surface area by introducing porosity with tailored pore size. This paper presents a synthesis route for the preparation of mesoporous zirconia u...
متن کاملSmall-angle X-ray scattering study of the interaction of poly(ethylene oxide)-b-poly(propylene oxide)-b-poly(ethylene oxide) triblock copolymers with lipid bilayers.
The relationship between molecular architecture and the nature of interactions with lipid bilayers has been studied for a series of poly(ethylene oxide)-b-poly(propylene oxide)-b-poly(ethylene oxide) (PEO-PPO-PEO) triblock copolymers using small-angle X-ray scattering (SAXS) and thermal analysis (differential scanning calorimetry, DSC). The number of molecular repeat units in the hydrophobic po...
متن کامل