Optimizing Melamine Resin Microspheres with Excess Formaldehyde for the SERS Substrate
نویسندگان
چکیده
Influence of the excess monomer within the synthetic reaction solution of melamine resin microspheres (MFMSs) on the surface-enhanced Raman spectroscopy (SERS) enhancement from Rhodamine 6G (R6G) was investigated, where the R6G was adsorbed on the silver nanoparticles (AgNPs) that were loaded on the MFMSs. Surface characteristics of the MFMSs were modified by the excess monomer (i.e., the excessive melamine or formaldehyde) through its terminal overreaction, which can be simply controlled by some of the synthetic reaction conditions, thus further allowing us to optimize the assembly of the loaded AgNPs for the SERS detection. These SERS substrates incorporating the optimized MFMSs with the excess formaldehyde can also be used for tracing analyses of more environmental and food contaminants.
منابع مشابه
Preparation of Monodisperse Melamine-Formaldehyde Microspheres via Dispersed Polycondensation
We have successfully synthesized relatively monodisperse and cross-linked melamine-formaldehyde (MF) microspheres by dispersed polycondensation and subsequent pH adjustment with serum replacement cleaning. The average particle sizes ( : weight-average and : number-average), the polydispersity index ( ), the number of particles Np, and the gel content of the M-F microspheres were observed by var...
متن کاملThe Effects of Adding Melamine at Different Resin Synthesis Points of Low Mole Ratio Urea-Melamine- Formaldehyde (UMF) Resins
Low mole ratio urea-melamine-formaldehyde (UMF) resins synthesized with 2.5% and 5.0% melamine levels added at the beginning, middle, and end points of the first alkaline step of the typical urea-formaldehyde (UF) resin synthesis procedure were compared with typical UMF resins synthesized with melamine additions made at the final alkaline step. Various resin analysis, particleboard preparation,...
متن کاملFORMALDEHYDE EXPOSURE AND ITS HEALTH HAZARDS IN A MELAMINE DINNERWARE MANUFACTURING INDUSTRY
This paper reports on formaldehyde exposure and its health hazards in a melamine manufacturing industry. The mean of workers' exposure was measured according to 3500 NJOSH and was found to be 1.44±O.2l, and 2. 17±O.24 ppm in morning and evening shifts, respectively. For stationary ones it was 1.37±O.20, and 2.06±O.25ppm, respectively. The results show that formaldehyde concentration at the...
متن کاملMicroencapsulation of Butyl Stearate as Phase Change Material by Melamine Formaldehyde Shell for Thermal Energy Storage
Butyl stearate as a phase change material was microencapsulated within melamine-formaldehyde resin using emulsion polymerization. Morphology and thermal specification of produced microcapsules were studied by Fourier transform infrared spectroscopy, FT-IR, scanning electron microscopy, SEM, and Differential scanning calorimetry analysis, DSC. FT-IR spectra validated the existence of the butyl s...
متن کاملEffects of Melamine Addition Stage on the Performance and Curing Behavior of Melamine-Urea-Formaldehyde (MUF) Resin
Three formaldehyde-based resins were prepared: urea-formaldehyde (UF) resin without melamine modifier (named UF0 resin) and melamineurea-formaldehyde (MUF) resins with melamine modifier added at two different synthesis stages (named MUF1 resin and MUF2 resin). The effects of the melamine addition stage on the performance and curing behavior of MUF resin were studied. Three-ply plywood bonded by...
متن کامل