Influence of Preferred Orientation on the Electrical Conductivity of Fluorine-Doped Tin Oxide Films
نویسندگان
چکیده
Current development of high-performance transparent conductive oxide (TCO) films is limited with tradeoff between carrier mobility and concentration since none of them can be improved without sacrificing the other. In this study, we prepare fluorine doped tin oxide (FTO) films by chemical vapor deposition with inclusions of different additives and report that the mobility can be varied from 0.65 to 28.5 cm(2) V(-1) s(-1) without reducing the achieved high carrier concentration of 4 × 10(20) cm(-3). Such an increase in mobility is shown to be clearly associated with the development of (200) preferred orientation (PO) but concurrent degradation of (110) PO in films. Thus, at a constant high carrier concentration, the electrical conductivity can be improved via carrier mobility simply by PO control. Such a one-step approach avoiding conventional post-deposition treatment is suggested for developing next-generation FTO as well as other TCO films with better than ever conductivities.
منابع مشابه
Translation Effects in Fluorine Doped Tin Oxide Thin Film Properties by Atmospheric Pressure Chemical Vapour Deposition
In this work, the impact of translation rates in fluorine doped tin oxide (FTO) thin films using atmospheric pressure chemical vapour deposition (APCVD) were studied. We demonstrated that by adjusting the translation speeds of the susceptor, the growth rates of the FTO films varied and hence many of the film properties were modified. X-ray powder diffraction showed an increased preferred orient...
متن کاملOptical properties of indium tin oxide and fluorine-doped tin oxide surfaces: correlation of reflectivity, skin depth, and plasmon frequency with conductivity
Variable angle reflectance FTIR was used to investigate the reflectance of thin films of either indium tin oxide (ITO) or fluorine-doped tin oxide (SFO) on glass substrates in the mid-IR. The reflectance was observed to depend on the incident angle, wavenumber, and the polarization used. The Drude model and the Fresnel equations for reflection at a single dielectric boundary were used to interp...
متن کاملCharacterization of Pure and Antimony Doped SnO2 Thin Films Prepared by the Sol-Gel Technique
Pure and antimony doped SnO2 thin films have been prepared by the sol-gel dip coating technique on glass substrate using starting material SnCl2.2H2O as a host and SbCl3 as a dopant. Our experimental results revealed that, the quality of the coated films on the glass depends on process parameters. The effect of annealing temperature, dipping numbe...
متن کاملOptoelectronic Properties of PbS Films: Effect of Carrier Gas
In this study, lead sulfide (PbS) films were grown on Fluorine-doped TinOxide (FTO) glass substrate by thermal evaporation in a horizontal furnace toinvestigate carrier gas effect on structural, morphological, elemental, optical, electricaland photovoltaic properties of PbS. X-ray diffraction (XRD) patterns confirmed theformation of cubic polycrystalline PbS particles fo...
متن کاملSynthesis and Characterization of Zn-doped and un-doped SnO2 nanostructures for PV Applications
Tin oxide nanostructures, un-doped and Zn-doped, have been prepared by conventional sol-gel technique. Research grade tin chloride (SnCl2.2H2O) and zinc acetate (Zn(O2C2H3)2) were used as tin and zinc sources. Ethylene glycol and alcohol were used as solvents under different synthesis conditions. Transparent un-doped and Zn-doped SnO2 sol was prepared after continuous stirring and refluxing at ...
متن کامل