Characterization of a Continuous , Very Narrowband Seismic Signal near 2 . 08 Hz
نویسندگان
چکیده
We have detected a continuous seismic signal near 2.08 Hz using data from a portable seismic array, 1280 km long, deployed in Siberia and Mongolia. The signal can be observed on almost all the stations along the profile. The amplitude and the frequency of the signal show a clear daily cycle, and their temporal variations are similar at different stations, suggesting that the signals observed at different stations have a common source. We performed a nonlinear inversion of the amplitude of the signal and found that the geometrical-spreading factor is about 0.6, implying that the signal is most likely to be a form of surface waves. The source location found by the inversion is in the vicinity of the city of Irkutsk, which is about 50 km north of Lake Baikal.
منابع مشابه
On-Mote Compressive Sampling in Wireless Seismic Sensor Networks
Implementing a wireless sensor network capable of near real-time, continuous (e.g., 500 Hz sampling rate), geophysical sensing requires a better approach than a simplistic sense, store, send methodology. Transmitting all sensor data is very power intensive, as the radio consumes much more power than other wireless mote components (e.g., CPU, ADC) [1]. To address the need for a lightweight data ...
متن کاملWindowing Effects of Short Time Fourier Transform on Wideband Array Signal Processing Using Maximum Likelihood Estimation
During the last two decades, Maximum Likelihood estimation (ML) has been used to determine Direction Of Arrival (DOA) and signals propagated by the sources, using narrowband array signals. The algorithm fails in the case of wideband signals. As an attempt by the present study to overcome the problem, the array outputs are transformed into narrowband frequency bins, using short time Fourier tran...
متن کاملWindowing Effects of Short Time Fourier Transform on Wideband Array Signal Processing Using Maximum Likelihood Estimation
During the last two decades, Maximum Likelihood estimation (ML) has been used to determine Direction Of Arrival (DOA) and signals propagated by the sources, using narrowband array signals. The algorithm fails in the case of wideband signals. As an attempt by the present study to overcome the problem, the array outputs are transformed into narrowband frequency bins, using short time Fourier tran...
متن کاملSeismic Acoustic Ratio Estimates Using a Moving Vehicle Source
Seismic and acoustic noise from moving tracked vehicles was used to determine the seismic to acoustic signal coupling ratio (SAR) in the ground. The seismic signal received on a geophone contains some energy that has propagated as seismic waves and some energy that couples from acoustic waves to seismic waves in the vicinity of the geophone. We use the frequency domain coherence between the mic...
متن کاملDetection of Long-Duration Narrowband Processes
In this paper we are concerned with the detection of quiet narrowband signals. More specifically, we assume that these signals are: 1) extremely weak, with a signal-to-noise ratio (SNR) of ¡20 dB or below on a per-sample basis, 2) moderately long, of the order of minutes or tens of minutes, and 3) narrowband but not tonal, with, for example, a bandwidth of a few tens of Hz at a sampling rate of...
متن کامل