Comments on "Evaluation of the mean error-free interval of a noisy data channel"

نویسندگان

  • H. M. de Lima
  • Otto Carlos Muniz Bandeira Duarte
چکیده

|This paper corrects a few results reported in 1]. It shows that, for very long data strings, the Mean Error-Free Interval as a function of the packet error rate P is not discontinuous. In addition, the corrected results are extended to point-to-multipoint environment. In 1], Georganas et al. derived expressions for the Mean-Error Free Interval (MEFI) in a data string of B packets in a packet-oriented data transmission system. An Error-Free Interval (EFI) was deened as the number of consecutive error-free packets between two packets in error. Expressions were derived for the conditional (given that i packets out of B are in error) and unconditional MEFI's. However , as will be shown in this letter, the evaluation of these MEFI's must take into account that the length K of an EFI can be equal to zero and not only for K = 1; 2 An EFI of length zero corresponds to the interval between two contiguous packets in error. The notation and assumptions utilized in this correspondence are identical to those in the mentioned paper. Thus, the packets have L bits, including overhead, the Bit Error Rate (BER) is p, the errors are statistically independent, the probability of a packet being in error is: and the probability of i packets being in error among the total B is given by the binomial distribution: Using the same steps utilized in 1], it is not diicult to show that equation 3 also is valid for K = 0. Hence, equation 3 becomes valid for 0 K B ?i. This correction implies that the expressions for E(B; i) (equation 5), E 1 (B) (equation 8) and E 1 (1) (equations 9 and 10) in 1] must also be corrected. The corrected expression for the Mean Error-Free Interval given that i packets out of B are in error (E(B; i) in Proposition 2 of 1]) is: The corrected expression for the unconditional Mean Error-Free Interval in a data string of B packets, measured in packet lengths (E 1 (B) in Proposition 3 of 1]), is: (9) The same result can be obtained by a diierent way: given that a packet has been received in error, the probability of the EFI length, between itself and the next packet

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

GENERALIZED JOINT HIGHER-RANK NUMERICAL RANGE

The rank-k numerical range has a close connection to the construction of quantum error correction code for a noisy quantum channel. For noisy quantum channel, a quantum error correcting code of dimension k exists if and only if the associated joint rank-k numerical range is non-empty. In this paper the notion of joint rank-k numerical range is generalized and some statements of [2011, Generaliz...

متن کامل

A New Unequal Error Protection Technique Based on the Mutual Information of the MPEG-4 Video Frames over Wireless Networks

The performance of video transmission over wireless channels is limited by the channel noise. Thus many error resilience tools have been incorporated into the MPEG-4 video compression method. In addition to these tools, the unequal error protection (UEP) technique has been proposed to protect the different parts in an MPEG-4 video packet with different channel coding rates based on the rate...

متن کامل

A Procedure for Building Confidence Interval on the Mean of Simulation Output Data

One of the existing methods to build a confidence interval (c.i.) for the mean response in a single steady state simulation system is the batch means method. This method, compared to the other existing methods (autoregressive representation, regenerative cycles, spectrum analysis, standardized time series), is quite easy to understand and to implement and performs relatively well. However, the ...

متن کامل

System Identification Based on Frequency Response Noisy Data

In this paper, a new algorithm for system identification based on frequency response is presented. In this method, given a set of magnitudes and phases of the system transfer function in a set of discrete frequencies, a system of linear equations is derived which has a unique and exact solution for the coefficients of the transfer function provided that the data is noise-free and the degrees of...

متن کامل

System Identification Based on Frequency Response Noisy Data

In this paper, a new algorithm for system identification based on frequency response is presented. In this method, given a set of magnitudes and phases of the system transfer function in a set of discrete frequencies, a system of linear equations is derived which has a unique and exact solution for the coefficients of the transfer function provided that the data is noise-free and the degrees of...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • IEEE Trans. Communications

دوره 44  شماره 

صفحات  -

تاریخ انتشار 1996