FA 8.1: A 115mW CMOS GPS Receiver

نویسندگان

  • D. Shaeffer
  • A. Shahani
  • S. Mohan
  • H. Samavati
  • H. Rategh
  • M. Hershenson
  • M. Xu
  • C. Yue
  • D. Eddleman
  • T. Lee
چکیده

The global positioning system (GPS) provides accurate positioning and timing information that is useful in many applications. In particular, portable consumer GPS applications require cheap compact low-power receivers. This 115mW receiver, implemented in an analog 0.5μm CMOS technology, comprises the entire radio-frequency (RF) and analog sections in addition to the local oscillator (LO) frequency synthesizer and a pair of oversampled A/D converters.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Design and Implementation of Low-power Cmos Radio Receivers a Dissertation Submitted to the Department of Electrical Engineering and the Committee on Graduate Studies of Stanford University in Partial Fulfillment of the Requirements for the Degree of Doctor of Philosophy

A S CMOS technologies continue to enjoy the bene ts of aggressive scaling, they become increasingly attractive for use in wireless receivers. Peak device fT 's on the order of 15GHz are available with 0.5 m CMOS devices, making possible CMOS implementations of radio receivers in the 1-2GHz frequency range. One wireless system in this range that is particularly amenable to integration is a Globa...

متن کامل

A Programmable Fully-Integrated GPS receiver in 0.18µm CMOS with Test Circuits

A 0.18μm single chip GPS receiver with 19.5 mA power consumption is implemented in 6.5 mm. A serial input digital control with additional testing structure not adding more than 4% to the Si area are used to the actual RF circuits in case of problems minimizing the number of Si runs. Index Terms — Testability, Test Structure, CMOS Radio, Global Positioning System (GPS), Receiver.

متن کامل

Quadrature Sampling Mixer Topology for SAW-Less GPS Receivers in 0.18μm CMOS

Abstract This paper describes a new switching topology of a sampling mixer for SAW-less GPS (L1 band) receivers. The GPS receiver with the new mixer achieved NF 2.5dB and good blocking performance. In an alternative implementation, the mixer is stacked under a Quadrature VCO to reuse supply current. As a result, the current consumption of the GPS receiver is 11mA from 1.8V supply while maintain...

متن کامل

CMOS Front-End Circuits of Dual-Band GPS Receiver

A RF front-end chip for a dual-band Global Positioning System (GPS) receiver for L1 and L2 bands is designed using 0.25 μm CMOS technology. All function blocks of the GPS front-end are integrated onto one chip. The low noise amplifier has input matching over a wide frequency range to handle the L1 and L2 bands. This receiver uses a dualband image-reject mixer with the quadrature mixer sharing a...

متن کامل

Design of 1.8V 1GHz 0.18 m CMOS LNA for GPS

the low noise amplifier is the key part for front-end device of the receiver in the GPS. A 1.8V 0.18um CMOS LNA for GPS applications has been designed. Two kinds of low noise amplifier (LNA) for single-end cascade structure and differential cascade structure respectively are presented in this paper. Cadence software is used to optimize the two circuits. It provides a series of good results in N...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1998