Rubber Friction in Aqueous Solutions Containing Ions
نویسندگان
چکیده
Lubricants ordinarily operate by keeping two sliding surfaces separated. The efficiency of a lubricant may be expressed by equations of hydrodynamics where the mechanical properties of the films of lubricants are adequately defined by the properties of bulk lubricant. In the case of water lubrication of black rubber at slow speeds and low pressures the lubricating ability of water is shown to be enhanced by addition of electrolytes to the water. It is thought that negative ions from the electrolytic solution collect on each sliding surface, repel each other and prevent the close approach of two sliding surfaces. Thus a thicker water film exists between the sliding surfaces than if the ion layers did not exist. The thicker film results in a reduced viscous drag force, lower than can be accounted for by conventional hydrodynamics.
منابع مشابه
Damping Behavior of the Phenolic Based Composite Friction Materials Containing Thermoplastic Elastomers (TPEs)
Attempts have been made for the first time to produce a friction material with thermal sensitive modulus by the inclusion of combined plastic/rubber properties of thermoplastic elastomers (TPE) as viscoelastic polymeric materials into the formulation for the purpose of increasing the damping behavior. In order to evaluate the viscoelastic parameters such as loss factor (tan δ) and elastic m...
متن کاملComparison of biosorption of cadmium ions from aqueous solutions by the lichens Acarospora strigata, Lecanora muralis and Caloplaca aurantia
Introduction: Biosorption of heavy metals can be an effective process for the removal of heavy metal ions from aqueous solutions. Also, living lichens are known to accumulate metals across their surface. Materials and methods: In this study, the biosorption of cadmium ions Cd (II) by the lichens Acarospora strigata, Lecanora muralis and Caloplaca aurantia was investigated in aqueous solution i...
متن کاملAdsorption of Co(II) ions from aqueous solutions using NiFe2O4 nanoparticles
In this study, NiFe2O4 nanoparticles (NiFe2O4 NPs) were prepared through co-precipitation method and subsequently used for the removal of Co(II) ions from aqueous solutions. The NiFe2O4 NPs were characterized by transmission electron microscopy (TEM), X-ray diffraction spectrometry (XRD), and Brunauer-Emmett-Teller (BET) surface area analysis. In batch tests, the effects of variables such as pH...
متن کاملOn friction behavior of rubber on concrete surfaces
T h e frict,ion behavior of rubber materials on various contact surfaces is strongly affected by the contact pressure and the relative sliding velocity. Based on a great number of experiment,^ of rubber block moving on concrete surfaces. a friction law is present,ed in this paper. It is characterized b~ a dependence on contact pressure and sliding velocity. The identification of the required pa...
متن کاملPreparation of Nanochitosan as an Effective Sorbent for the Removal of Copper Ions from Aqueous Solutions
The most important pollutants in wastewater are heavy metal ions. In this paper, the effects of various parameters such as pH, contact time, initial concentration, and temperature on the adsorption of Cu (II) by nanochitosan (NCS) was investigated in batch experiment. Nanochitosan was prepared based on ionic gelation and characterized by means of Fourier Transform Infrared Spectroscopy (FTIR),...
متن کامل