Seat height in handrim wheelchair propulsion.
نویسندگان
چکیده
To study the effect of seat height on the cardiorespiratory system and kinematics in handrim wheelchair ambulation, nine non-wheelchair users participated in a wheelchair exercise experiment on a motor-driven treadmill. The subjects conducted five progressive exercise tests. After an initial try-out test, four tests were performed at different standardized seat heights of 100, 120, 140, and 160 degrees elbow extension (subject sitting erect, hands on the rim in top-dead-center = 12.00 hrs; full extension = 180 degrees). Each test consisted of four 3-minute exercise blocks at speeds of respectively 0.55, 0.83, 1.11, and 1.39 m.s-1 (2-5 km.hr-1). Analysis of variance revealed significant effects of seat height (P less than 0.05) on gross mechanical efficiency (ME), oxygen cost, push range, and push duration, and on the ranges of motion in the different arm segments and trunk. Mean ME appeared higher at the lower seat heights of 100 and 120 degrees elbow extension. This is reflected in an enhanced oxygen consumption at seat heights of 140 and 160 degrees elbow extension. Simultaneously, the push range showed a 15 to 20 degree decrease with increasing seat height, which is reflected in a decreased push duration. In the push phase, decreases in retroflexion and abduction/adduction of the upper arm were seen. The trunk shifted further forward, and the motion range in the elbow joint shifted to extension with increasing seat height. No shifts in minimum and maximum angular velocities were seen with increasing seat height. The results showed an interrelationship between wheelchair seat height and both cardiorespiratory and kinematic parameters. With respect to the cardiorespiratory system, the optimization of the wheelchair geometry, based on functional characteristics of the user, appears beneficial.
منابع مشابه
The effect of seat position on wheelchair propulsion biomechanics.
This study examined the effect of seat position on handrim biomechanics. Thirteen experienced users propelled a wheelchair over a smooth level floor at a self-selected speed. Kinetic and temporal-distance data were collected with the use of an instrumented rim and a motion analysis system. A custom-designed axle was used to change the seat position. We used repeated measures analysis of varianc...
متن کاملA theoretical analysis of the influence of wheelchair seat position on upper extremity demand.
BACKGROUND The high physical demands placed on the upper extremity during manual wheelchair propulsion can lead to pain and overuse injuries that further reduce user independence and quality of life. Seat position is an adjustable parameter that can influence the mechanical loads placed on the upper extremity. The purpose of this study was to use a musculoskeletal model and forward dynamics sim...
متن کاملDesign and Fabrication of an Instrumented Handrim to Measure the Kinetic and Kinematic Information by the Hand of User for 3D Analysis of Manual Wheelchair Propulsion Dynamics
The repetitious nature of propelling a wheelchair has been associated with the high incidence of injury among manual wheelchair users (MWUs), mainly in the shoulder, elbow and wrist. Recent literature has found a link between handrim biomechanics and risk of injury to the upper extremity. The valid measurement of three-dimensional net joint forces and torques, however, can lead to a better unde...
متن کاملEffects of Wheelchair Seat-height Settings on Alternating Lower Limb Propulsion With Both Legs.
This study investigated the effects of seat-height settings of wheelchairs with alternating propulsion with both legs. Seven healthy individuals with no orthopedic disease participated. Flexion angles at initial contact (FA-IC) of each joint, range of motion during propulsion period (ROM-PP), and ground reaction force (GRF) were measured using a three dimensional motion capture system and force...
متن کاملA comparison of methods to compute the point of force application in handrim wheelchair propulsion: a technical note.
Several methods are available for computing the location of the point of force application (PFA) in manual wheelchair propulsion using kinetic data. We compared five different techniques for computing the PFA location in analysis of data from five wheelchair users propelling their own wheelchairs using their normal propulsion style. The effects of the assumptions used in the calculations on the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of rehabilitation research and development
دوره 26 4 شماره
صفحات -
تاریخ انتشار 1989