Defect detection of pipes using shearography and lock-in infrared thermography
نویسندگان
چکیده
Dept.of Mechnical Design Eng., Chosun Univ., 375 Seosuk-dong, Dong-gu, Gwangju, Korea, [email protected] In this study, shearography and infrared thermography were used for measuring the wall thinning defects of the nuclear power plants pipes. It is very important to measure the wall thinning defects inside the pipes, because the wall thinning defects cause damage or destruction of the pipes. The defects are mainly occurred by the effect of the flow accelerated corrosion of fluid which flows in pipes. As a result of experiment, length and depth of the defects which are located in the pipes was accurately measured. So, the wall thinning defects are evaluated quantitatively by using shearography and infrared thermography.
منابع مشابه
Comparison of the defect detection capabilities of flash thermography and vibration excitation shearography
The defect detection capabilities of transient thermography and shearography have been compared using optimum excitation methods for each technique: short pulse heating for thermography and vibration excitation using a piezoelectric transducer for shearography. A signal-to-noise ratio and limit of detection analysis has been performed on defect images obtained by the two techniques using the di...
متن کاملLock-in Thermography Image Procesing
Composite materials have appropriate thermal properties for detection flaws by means of non-destructive infrared thermography methods. Infrared thermography methods are based on tracking heat flow that has been induced by flood lamps. Lock-in thermography, as one of infrared thermography methods, is used in detection of flaws. Surface of specimen is periodically heated by heat flow in form of s...
متن کاملQuantitative Evaluation of Pulsed Thermography, Lock-in Thermography and Vibrothermography on Foreign Object Defect (FOD) in CFRP
In this article, optical excitation thermographic techniques, including pulsed thermography and lock-in thermography, were used to detect foreign object defect (FOD) and delamination in CFRP. Then, vibrothermography as an ultrasonic excitation technique was used to detect these defects for the comparative purposes. Different image processing methods, including cold image subtraction (CIS), prin...
متن کاملExperimental Detection of Composite Delamination Damage based on Ultrasonic Infrared Thermography
An experimental setup is designed to detect composite delamination damage based on ultrasonic infrared thermography. The ultrasonic infrared thermography system is composed by ultrasonic excitation system, infrared thermal imager and data acquisition system and two damaged composite plate specimens are produced in the experiment. The image processing methods including thresholding, filters, edg...
متن کاملNondestructive Evaluation of Plexiglas Materials Using Lock-in and Pulse Phase Infrared Thermography
− Lock-in and pulse phase infrared thermography measurement techniques have been exploited for quantitative assessment of subsurface defects in a reference specimen made of Plexiglas. Radiometric thermal images were post-processed using a contrast approach in the frequency domain, allowing defect depth location to be resolved with a relative combined standard uncertainty of about 7% for thickne...
متن کامل