Think Analog, Act Digital Is Continuous-time Signal Processing Dead ?
نویسندگان
چکیده
Dear Dr. Liebling, I am pleased to inform you that you were selected to the receive the 2004 Research Award of the Swiss Society of Biomedical Engineering for your thesis work “On Fresnelets, interference fringes, and digital holography”. The award will be presented during the general assembly of the SSBE, September 3, Zurich, Switzerland. Please, lets us know if 1) you will be present to receive the award, 2) you would be willing to give a 10 minutes presentation of the work during the general assembly. The award comes with a cash prize of 1000.CHF. Would you please send your banking information to the treasurer of the SSBE, Uli Diermann (Email:[email protected]), so that he can transfer the cash prize to your account ? I congratulate you on your achievement. With best regards,
منابع مشابه
DSP Software Development Lifecycle Issues
INTRODUCTION Digital Signal Processing (DSP) is the method of processing signals and data in order to enhance or modify those signals or to analyze those signals to determine specific information content. A typical DSP system (Figure 1) consists of a processor and other hardware used to convert outside analog signals to digital form and possibly back to analog (continuous) form. There is nothin...
متن کاملTime-Mode Signal Quantization for Use in Sigma-Delta Modulators
The rapid scaling in modern CMOS technology has motivated the researchers to design new analog-to-digital converter (ADC) architectures that can properly work in lower supply voltage. An exchanging the data quantization procedure from the amplitude to the time domain, can be a promising alternative well adapt with the technology scaling. This paper is going to review the recent development in t...
متن کاملECE 438 - Laboratory 4 : Sampling and Reconstruction of Continuous - Time Signals
It is often desired to analyze and process continuous-time signals using a computer. However, in order to process a continuous-time signal, it must first be digitized. This means that the continuous-time signal must be sampled and quantized, forming a digital signal that can be stored in a computer. Analog systems can be converted to their discrete-time counterparts, and these digital systems t...
متن کاملTransition from analogue-to-digital nuclear electronics for precise gamma radiation spectroscopy: advantages and limitations
In this paper, digital signal processing for precise gamma ray spectroscopy is presented. The basis of this system is a 14bit waveform digitizer which samples the output of pre-amplifier signals directly. The advantages and limitations of the digital spectrometer compared with analog spectrometer has been tested and analyzed from precise gamma ray spectroscopy point of view. The results shows t...
متن کامل978 - 0 - 521 - 88775 - 5 - Digital Signal Processing System Analysis and Design : Second Edition Paulo
When we hear the word “signal” we may first think of a phenomenon that occurs continuously over time that carries some information. Most phenomena observed in nature are continuous in time, such as for instance our speech or heart beating, the temperature of the city where we live, the car speed during a given trip, the altitude of the airplane we are traveling in – these are typical continuous...
متن کامل