Design trade-offs for linear-phase FIR decimation filters and ΣΔ-modulators

نویسندگان

  • Anton Blad
  • Per Löwenborg
  • Håkan Johansson
چکیده

In this paper we examine the relation between signal-tonoise-ratio, oversampling ratio, transition bandwidth, and filter order for some commonly used sigma-delta-modulators and corresponding decimation filters. The decimation filters are equi-ripple finite impulse response filters and it is demonstrated that, for any given filter order, there exists an optimum choice of the stopband ripple and stopband edge which minimizes the signal-to-noise-ratio degradation.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A New Technique for Digital Pre-compensation in Iq Modulator

In DSP based IQ modulators generating CPFSK signals, departures from a flat-magnitude, linear phase frequency response in the pass bands of analogue reconstruction filters in the I and Q channels cause ripples in the modulator output signal envelope. These ripples then produce undesirable side-lobes in the output signal spectrum when the signal passes through non-linear elements in the transmis...

متن کامل

Design of a Decimation Filter for Novel Sigma-delta Modulator

The steps involved in the design of decimation filter for high-resolution sigma-delta (ΣΔ) A/D converter are described. The design of a decimation filter is proposed that employs three stage – one Cascaded Integrator Comb filter (CIC) followed by two finite impulse response (FIR) filters. This approach eliminates the need for multiplication, requires a maximum clock frequency equal to the sampl...

متن کامل

POWER-Area-Performance Characteristics of FPGA-based Sigma-Delta FIR Filters

While one-bit ΣΔ modulators are widely used in Analog to Digital conversion stages due to their inherent linearity and precision, it is less common for the entire digital processing path to operate in single bit mode at the oversampled rate of the conversion system. The conventional approach has been to decimate the signal bit stream after conversion and for the remaining processing to be perfo...

متن کامل

A class of reconfigurable and low-complexity two-stage Nyquist filters

This paper introduces a class of reconfigurable two-stage Nyquist filters where the Farrow structure realizes the polyphase components of linear-phase finite-length impulse response (FIR) filters. By adjusting the variable predetermined multipliers of the Farrow structure, various linear-phase FIR Nyquist filters and integer interpolation/decimation structures are obtained, online. However, the...

متن کامل

Cascading Sharpened CIC and Polyphase FIR Filter for Decimation Filter

This paper is concerned with design of cascading CIC filter and FIR filter to improve the passband droop and stopband attenuation for decimation filter. Decimation filter has wide application in both analog and digital systems for data rate conversion as well as filtering. We have three class of filters FIR, IIR and CIC filters. IIR filters are simpler in structure, but not satisfy linear phase...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006