Solid-State Bipolar Marx Converter with Output Transformer and Energy Recovery
نویسندگان
چکیده
The purpose of this paper is to present and discuss a general HV topology of the solid-state Marx modulator, for unipolar or bipolar generation connected with a step-up transformer to increase the output voltage applied to a resistive load. Due to the use of an output transformer, discussion about the reset of the transformer is made to guarantee zero average voltage applied to the primary. It is also discussed the transformer magnetizing energy recovering back to the energy storage capacitors. Simulation results for a circuit that generates 100 kV pulses using 1000 V semiconductors are presented and discussed regarding the voltage and current stress on the semiconductors and result obtained.
منابع مشابه
Analyses of Klystron Modulator Approaches for Nlc
Major changes to the Next Linear Collider (NLC) design were facilitated by the experimental testing of the 75 MW X-band klystron at a 3.0 μsec pulse width 1 and new component development allowing the delay line distribution system (DLDS) to operate with eight bins instead of four. This change has a direct effect on the design of the klystron modulator. The general approaches, which are being st...
متن کاملMitigation of voltage sag, swell and power factor correction using solid-state transformer based matrix converter in output stage
Solid-state transformer (SST); Medium frequency transformer; AC/AC converter; Matrix converter Abstract This paper presents a novel topology of solid-state transformer (SST). In the design process, the AC/DC, DC/AC and AC/AC converters have been integrated to achieve higher efficiency. To obtain higher efficiency from other SST with DC-link topologies, the AC/DC and DC/AC converters have been i...
متن کاملSolid State Transformer Integration in Smart Grid System
The development of a Solid State Transformer (SST) that incorporates a DC-DC multiport converter to integrate both photovoltaic (PV) power generation and battery energy storage is presented in this dissertation. The DC-DC stage is based on a quad active-bridge (QAB) converter which not only provides isolation for the load, but also for the PV and storage. The AC-DC stage is implemented with a p...
متن کاملTransient Analysis Modeling of Modular Marx Multilevel Converters
This paper presents equivalent models of Modular Marx Multilevel Converter Diode (MCD) plus load, for bipolar or unipolar operation. With these models, it’s possible to analyze and understand the dynamic behavior of the pulse output voltage and current at the load. Simulation and experimental results, for different voltage levels, and various types of load are presented. Keywords-Modeling , Mul...
متن کاملA Novel Dynamic Voltage Regulator with a Multi-level AC/AC Converter
This article proposed a novel topology of dynamic voltage regulator using transformer and PWM multi-level AC/AC converter. In this paper for finding the best value of duty ratio for switches to minimize the THD, the GA algorithm has been used and THD output voltage is assumed to be fitness function. The proposed voltage regulator employs multi-level AC/AC converter to generate compensation volt...
متن کامل