Wide - Band Push - Pull Amplifier for High Gradient Cavity
نویسندگان
چکیده
A high gradient cavity(HGC) using high permeability magnetic alloy (MA) cores has been developed at KEK for the JHF(Japan Hadron Facility) proton synchrotrons. In this paper, we describe two types of push-pull amplifiers to drive the cavity, which were constructed for verifying the cavity performance. An accelerating voltage of 20kV across the gap of the HGC was generated by the high power push-pull amplifier. This is equivalent to high gradient field of 50kV/m. The other amplifier and the cavity were prepared for accelerating heavy ions at the HIMAC(Heavy Ion Medical Accelerator in Chiba). For this purpose, it is necessary to sweep the frequency over the wide range from 1MHz to 8MHz.
منابع مشابه
The First Beam Acceleration Test Using High Gradient Cavity at Himac
The HGC loaded with MA cores has been developed[1] for the JHF (Japan Hadron Facility) proton synchrotrons. The maximum voltage of 20 kV has been obtained by the cavity of 40 cm in length. The cavity was driven by a pushpull amplifier using two 150 kW tetrodes. The frequency sweeping from 1 to 5 MHz has been achieved without any tuning circuit because of its broadband characteristics of the MA-...
متن کاملNonlinear Analysis of a Power Amplifier inc C Band and Load Pull Technique Calculation USING VOLTERRA SERIES
In recent years, nonlinear circuit analysis techniques have been extensively investigated. One of the most important reasons is the application development of solid-state devices at microwave frequencies. Different methods have been used to analysis large signal behavior of these devices. In this paper load-pull curves (one of design requirement) are obtained using Volterra series. The main adv...
متن کاملIntegrated-Antenna Push–Pull Power Amplifiers
In this paper, the integrated-antenna concept is applied to push–pull power amplifiers (PA’s). In this approach, the antenna serves as an out-of-phase power combiner and tuned load for higher harmonics. This new architecture effectively has a near-zero loss output hybrid, and results in a high-efficiency PA. The first example is a narrow-band push–pull amplifier integrated with a dual-feed patc...
متن کاملA Novel Design in the Use of Planar Transformers for LDMOS Based Amplifiers in Bands II, III, DRM+, DVB-T and DAB+
The coaxial transformer-coupled push-pull circuitry has been used widely in HF and VHF amplifiers for many decades without significant changes in the topology of the transformers. Basic changes over the years concerned the construction and turns ratio of the transformers as has been imposed upon the newer technologies active devices demands. The balun transmission line transformers applied in p...
متن کاملHigh-Efficiency Push–Pull Power Amplifier Integrated with Quasi-Yagi Antenna
This paper presents a -band push–pull power amplifier integrated with a modified uniplanar quasi-Yagi antenna. In this circuit, corrugation is added to the truncated ground plane of the antenna so that it can be used for both out-of-phase power combining and second harmonic tuning. By using the active integrated antenna concept, this novel circuit eliminates the usage of an ordinary 180 hybrid ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1999