Influence of the porosity on the photoresponse of a liquid crystal elastomer
نویسندگان
چکیده
Azobenzene containing liquid crystal elastomers (LCEs) are among of the most prominent photoresponsive polymers due to their fast and reversible response to different light stimuli. To bring new functions into the present framework, novel modifications in bulk material morphology are required. Therefore, we produced azobenzene LCE free-standing films with different porosities. While the porosity provided macroscopic morphological changes, at the same time, it induced modifications in alignment of liquid crystal azobenzene units in the films. We found that a high porosity increased the photoresponse of the LCE in terms of bending angle with high significance. Moreover, the porous LCE films showed similar bending forces to those of pore-free LCE films.
منابع مشابه
CFD Simulation of Porosity and Particle Diameter Influence on Wall-to-Bed Heat Transfer in Trickle Bed Reactors
Wall-to-bed (or wall-to-fluid) heat transfer issues in trickle bed reactors (TBR) has an important impact on operation and efficiency in this category of reactors. In this study, the hydrodynamic and thermal behavior of trickle bed reactors was simulated by means of computational fluid dynamics (CFD) technique. The multiphase behavior of trickle bed reactor was studied by the implementation of ...
متن کاملThe Effects of Excitation Signal on the Resolution of the Liquid Crystal Capacitive Chemical and Biological Sensors
In this paper excitation characteristics of the Liquid Crystal (LC) capacitive chemical and biological sensor are examined and the optimum frequency and voltage range for the sensor interface are introduced. Interdigitated capacitor has been used for the sensor capacitance measurement and two different molecular orientations, homeotropic and homogenous, have been considered. The LC sensor capac...
متن کاملTemperature Tunability of Dielectric/ Liquid Crystal / Dielectric Photonic Crystal Structures
Recently, photonic crystals doped with liquid crystal (LC) material havegained much research interest. In this article new ternary one-dimensional photoniccrystal introduced and studied. The liquid crystal layer of 5CB and 5PCH is sandwichedby two dielectric layers. For the first time, we use four structures SiO2/UCF35/CaF2,SiO2/5CB/CaF2, NFK51/UCF35/NPSK53 and NFK51/5CB/NPSK53. The effect ofte...
متن کاملLiquid Crystal Electromechanical Elastomer: A Strong Future for Smectic A* Molecules
Electromechanical materials are very useful as actuators when small weight, and low to moderate force are needed to manipulate small objects. The Liquid Crystal Material Research center located in Boulder, Colorado in interested in developing a novel liquid crystal based electromechanical elastomer. De Vries liquid crystals organize into layers where the director is perpendicular to the layer n...
متن کاملImprovement the reflection coefficient of Waveguide-Fed Phased-Array Antenna utilizing Liquid Crystal
Abstract— This work investigates the improvement of the active reflection coefficient of waveguide-fed phased-array antenna using liquid crystal layers. The anisotropy properties of liquid crystal layer can be employed to eliminate blind scan angle and improve the wide angle impedance matching of the waveguide-fed phased array antennas. The authors have expressed the modal analysis of the waveg...
متن کامل